Product ID:N-5594 BROWN SILICONE ALKYD
MSDS Date:01/25/1994
FSC:8010
NIIN:01-263-9798
MSDS Number: BVBMK

NILES CHEMICAL PAINT CO

225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377

Preparer: MICHAEL LICHATOWICH

Cage: 02388

NILES CHEMICAL PAINT

307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

MINERAL SPIRITS (VAPOR PRESSURE 0 MM @ 20C)

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 34%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

SILICONE ALKYD

Fraction By Weight: 30%

COBALT COMPOUNDS (AS CO) (SARA III)

CAS: 7440-48-4

RTECS: GF8750000

Fraction By Weight: <1%

OSHA PEL 0.1 MG/M3

ACGIH TLV: 2 MG/M3

MANGANESE COMPOUNDS (AS MN) (SARA III)

CAS: 7439-96-5

RTECS: OO9275000

Fraction By Weight: <1%

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3

3.41 LBS/GAL

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES:SEVERE IRRIT, LACRIMATION,
REDNESS, BLURRED VISION. SKIN:REDNESS, IRRITATION, DEFATTING
(DERMATITIS). BREATHING:NASAL & RESP IRRIT, CNS DEPRESSION
(DIZZINESS,DROWSINESS,WEAKNESS,FATIGUE,CONFUSION ) NAUSEA,
HEADACHE, VERTIGO, UNCONSCIOUSNES, ASPHYXIATION. INGEST:GI IRRIT,
ABDOMINAL PAIN, NAUSEA, VOMITING, DIARRHEA.
Effects of Overexposure:TARGET ORGANS: SKIN, EYES, RESPIRATORY SYSTEM,
CNS
Medical Cond Aggravated by Exposure:NONE KNOWN

First Aid:INHAL:MOVE TO FRESH AIR IMMED.IF BREATH STOPS,GIVE ARTIF
RESPRTN.GET MED AID ASAP.SKIN:IMMED FLUSH W/PLENTY OF WATER.IF
MAT'L PENETRATES CLOTH,IMMED REMOVE CONTAM CLOTH & FLUSH SKIN
W/WATER.GET MED AI D.WASH CLOTH;DECONTAM SHOES BEFORE
REUSE.EYE:IMMED FLUSH W/WATER 15 MIN,LIFTING EYELIDS.GET MED AID
IMMED.INGEST:DRINK 1-2 GLASSES WATER.DON'T INDUCE VOMIT.SEE
DR/POISON CNTRL CTR IMMED.TREAT SYMPTOMS

Flash Point Method:TCC
Flash Point:107F,42C
Lower Limits:0.0
Upper Limits:0.8
Extinguishing Media:DRY CHEMICAL, FOAM, CO2
Fire Fighting Procedures:WEAR SCBA W/FULL FACPIECE (POSITIVE PRESSURE
MODE) & FULL PROTECT CLOTH. USE WATER TO COOL CLOSED CNTNR TO
PREVENT PRESSURE BLDUP/AUTO IGNIT/EXPLOSION W/HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNR CLSD. VAPOR HEAVIER THAN AIR,
TRAVEL ON GRND TO IGNIT SOURCE. NO HEAT/IGNIT. CLSD CNTNRS MAY
EXPLODE W/HEAT. APPLIC TO HOT SRFC REQ SPCL PRECAUTIONS.

Spill Release Procedures:ELIMINATE IGNITION SOURCES. MINIMIZE BREATHING
OF VAPORS & AVOID SKIN CONTACT. SMALL: ABSORB W/INERT MAT'L. SHOVEL
RECLAIMED LIQ & ABSORB INTO RECOVERY OR SALVAGE DRUMS FOR DISPOSAL.
LRG: DIKE & RECLA IM INTO RECOVERY OR SALVAGE DRUMS OR TANK TRUCK.

Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURE
AREAS OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT
IN USE. AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMPTY DRUMS.

Respiratory Protection:WEAR (5C-23C-75) FITTED 1/2 MASK OR FULL
FACEPIECE RESPIRATOR (NIOSH/MSHA) DURING & AFTER APPLICATION UNLESS
AIR MONITORING DEMONSTRATES VAPOR/MIST LEVELS ARE BELOW APPLICABLE
LIMITS. FOLLOW RESPIRATO R MANUFACTURER'S DIRECTIONS FOR USE.
Ventilation:VENT TO KEEP BELOW PEL/TLV.REMOVE DECOMP PRODUCTS FROMED
DURING WELDING/FLAME CUT.VENT VAPOR EMMIT FROM BAKING FINISHES.
Protective Gloves:WEAR CHEM RESISTANT GLOVES-NITRILE,VITON
Eye Protection:CHEM GOGGLES,SAFETY GLASSES,FACE SHIELD
Other Protective Equipment:WEAR CHEMICAL RESISTANT (NITRILE OR VITON)
GLOVES AND CLOTHING AS NEEDED TO PREVENT SKIN CONTACT.
Work Hygienic Practices:EMPLOYEES SHOULD WASH PROPTLY WHEN SKIN BECOMES
CONTAMINATED, OR BEFORE EATING SMOKING, OR USING RESTROOM.
Supplemental Safety and Health

Boiling Pt:B.P. Text:278 TO 398F
Vapor Density:> AIR
Spec Gravity:1.176
Viscosity:67 - 77 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS
Percent Volatiles by Volume:53.13
Corrosion Rate:MINIMAL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS
Stability Condition to Avoid:HIGH TEMPERATURES, SHOCK FROM DROPPING
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE
Conditions to Avoid Polymerization:HIGH TEMPERATURES, SHOCK FROM
DROPPING

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL,
STATE, AND FEDERAL REGULATIONS. EPA HAZARDOUS WASTE CODE: D001
(IGNITABLE).

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.