BVNMB - F-09P328, MIL-C-22750E 17875 WHITE AND (SUPDAT)
- MSDS: BVNMB
- Manufacturer: SEAGRAVE COATINGS CORP
- Product Name: F-09P328, MIL-C-22750E 17875 WHITE AND (SUPDAT)
- National Stock Number: 1440-LWW005424
Product Identification
Product ID:F-09P328, MIL-C-22750E 17875 WHITE AND (SUPDAT)
MSDS Date:09/18/1992
FSC:1440
NIIN:LWW005424
MSDS Number: BVNMB
Responsible Party
PORTSMOUTH, VA 23701
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 804-488-4411
Cage: 60163
Contractor
Telephone: 757-397-2223
Cage: 60163
Ingredients
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 35%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
10
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: 15%
OSHA PEL 10 MG/M3 RDUST; Z-3
ACGIH TLV: 0.1 MG/M3 RDUST
3 @20C.
CAS: 64742-94-5
RTECS: WF3100000
Fraction By Weight: 5%
OSHA PEL N/K
ACGIH TLV: 100 PPM (MFR)
83
CAS: 78-93-3
RTECS: EL6475000
Fraction By Weight: 20%
OSHA PEL 200 PPM
ACGIH TLV: 200 PPM/300STEL
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
EPOXY RESIN
CAS: 25068-38-6
RTECS: KC2100000
Fraction By Weight: 35%
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHAL:IRRITATION TO RESPIRATORY TRACT,
HEADACHE, DIZZINESS AND NAUSEA. SKIN CONT:PRIMARY IRRITATION. EYE
CONT:PRIMARY IRRITATION.
Explanation of Carcinogenicity:SILICA, CRYSTALLINE-QUARTZ:IARC
MONOGRAPHS, SUPPLEMENT. VOL 7, PG 341, 1987:GROUP 2A. NTP 6TH
ANNUAL RPT ON (SUPDAT)
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.
First Aid
First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR,
RESTORE BREATHING. CONSULT A PHYSICIAN. SKIN CONT:FLUSH W/WATER.
EYE CONT:FLUSH IMMEDIATELY WITH LARGE AMOUNTS OF WATER FOR AT LEAST
15 MI NUTES. CONSULT A PHYSICIAN.
Fire Fighting
Flash Point Method:TCC
Flash Point:25.0F,-3.9C
Lower Limits:0.8%
Upper Limits:7.0%
Extinguishing Media:FOAM, WATER FOG, DRY CHEMICAL.
Fire Fighting Procedures:NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP .
WATER MAY BE USED TO COOL CLSD CNTNRS TO PVNT PRESS BUILD-UP & POSS
AUTOIGNIT/EXPLO WHEN EXPOS TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, SPARKS AND OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN EXPOSED
TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES, AND ANYTHING WHICH COULD CAUSE
FIRE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN A COOL DRY AREA WITH
VENTILATION SUITABLE FOR STORING MATLS. PROVIDE RESPIRATORY
PROTECTION AGAINST FUMES GENERATED DURING BURNING.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR SUITABLE FOR
MATLS. NIOSH/MSHA APPRVD CHEMICAL/MECHANICAL FILTERS REC WHEN
VENTILATION IS RESTRICTED. NIOSH/MSHA APPRVD AIRLINE TYPE
RESPIRATORS/HOODS RECOMMENDED IN CON FINED AREAS.
Ventilation:SUFFICIENT VENT, IN VOLUME & PATTERN, SHOULD BE PROVIDED TO
KEEP AIR CONTAM BELOW CURRENT APPLIC OSHA (SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEM GOGG/SIDESHLDS/FACE SHIELD.
Other Protective Equipment:USE PROT CREAMS WHERE SKIN CONT IS LIKELY.
REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREA ONLY.
Supplemental Safety and Health
MFR TRADE NAME/PART NO:COLORS EPOXY. EXPLAN OF CARCIN:CARCINOGENS,
1991:ANTICIPATED TO BE CARCINOGEN. VENT:PERMISSIBLE EXPOSURE
LIMIT/ACGIH'S TLV LIMIT.
Chemical Properties
Boiling Pt:B.P. Text:>175F,>79C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.49
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:WHITE LIQUID, KETONE SOLVENTS ODOR
Percent Volatiles by Volume:37.3
Stability
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:AS WITH ANY OTHER ORGANIC MATL, COMBUSTION
WILL PRODUCE CRBON DIOXIDE AND PROBABLY CARBON MONOXIDE.
Hazardous Decomposition Products:OXIDIZING MATERIALS CAN CAUSE A
VIGOROUS REACTION.
Disposal
Waste Disposal Methods:SOAK LIQUIDS W/SAWDUST OR RAGS & REMOVE. FLUSH
W/WATER IF POSSIBLE. AVOID SKIN CONT. DISPOSAL SHOULD BE IN
ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.