Product ID:POLYESTER GLAZING PUTTY, A400
MSDS Date:01/05/1991
FSC:8030
NIIN:00N053545
MSDS Number: BVPXH

FIBRE GLASS-EVERCOAT CO INC

6600 CORNELL ROAD
CINCINNATI, OH 45242
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 800-729-7600

Preparer: JEFF ZYCH

Cage: 18731

FIBRE GLASS-EVERCOAT CO INC

CINCINNATI, OH 45242 US

Telephone: 513-489-7600

Cage: 18731

295F,146C.

CAS: 100-42-5

RTECS: WL3675000

Fraction By Weight: 17.80%

OSHA PEL 100 PPM

ACGIH TLV: S,50PPM/100STEL

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

POLYESTER RESIN

Fraction By Weight: 20%

OSHA PEL N/K

ACGIH TLV: N/K

TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (TALC (NON

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: 50%

OSHA PEL 0.2 FIBERS/CC

ACGIH TLV: 0.2 FIBERS/CC

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10-15%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

0

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INHAL:VAP MAY CAUSE NOSE, THROAT
& RESP TRACT IRRIT. HIGH CONC MAY CAUSE HDCH & NAUS, RPTED HIGH
CONC EXPOS MAY CAUSE LIVER & KIDNEY DMG. SKIN:PRLNGD/FREQUENT SKIN
CONT MAY CAUSE DEFAT, DRYNESS W/IRRIT POSS DERM. EYE:MAY CAUSE
TEARING & IRRIT. SKIN ABSORP:DERM & IRRIT. INGEST:MAY CAUSE GI
DISTURB,(EFTS OF OVEREXP
Explanation of Carcinogenicity:STYRENE:IARC MONO, SUPPLEMENT, VOL 7, PG
345, 1987:GROUP 2B. ANIMAL:NERV SYS.
Effects of Overexposure:HLTH HAZ:PAIN & DISCOMFORT.
CHRONIC:INTERNATIONAL AGENCY FOR RESEARCH ON CANCER (IARC) HAS
CLASSED STYRENE AS POSS HUMAN CARCIN (CLASS 2-B). 2-B
CLASSIFICATION IS NOT BASED ON NEW EVID THAT STYRENE M IGHT BE
CARCIN BUT ON REVISED IARC CLASSIFICATION SYSTEM AND NEW EVIDENCE
FOR STYRENE OXIDE.
Medical Cond Aggravated by Exposure:LIVER AND KIDNEY DISORDERS.

First Aid:SKIN:WASH W/SOAP & WATER. EYES:FLUSH W/WATER FOR 15 MINUTES &
GET MED ATTN. INHAL:REMOVE VICTIM FROM EXPOSURE. IF UNCONSCIOUS
GIVE ARTF RESP OR OXYGEN AS NEEDED. GET MED ATTN. INGEST:DO NOT
INDUCE VOM ITING (ASPIRATION HAZARD). GET MED ATTN.

Flash Point Method:CC
Flash Point:98.0F,36.7C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:POLYMERIZATION MAY TAKE PLACE AT ELEVATED
TEMPERATURE SUCH AS IN A FIRE. IF CONTAINED, VIOLENT RUPTURE MAY
RESULT.

Spill Release Procedures:REMOVE SOURCES OF IGNITION. ABSORB SPILL WITH
ABSORBENT MATERIAL SUCH AS VERMICULITE OR SAND.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:AVOID STORAGE ABOVE 100F. STORE ONLY
IN ORIGINAL CONTAINERS.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:NIOSH/MSHA APPROVED CANISTER TYPE RESPIRATOR
MUST BE WORN TO PVNT INHAL OF VAPORS/SPRAY MISTS WHEN TLV OR PEL IS
EXCEEDED. WEAR NIOSH/MSHA MASK WHEN SANDING CURED PRODUCT.
Ventilation:SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:PLASTIC/CHEM RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKER GOGGLES .
Other Protective Equipment:REMOVE & WASH CONTAMD CLOTHING. USE A
BARRIER CREAM SUCH AS GLOVE COAT WHEN USING THE PRODUCT.
Work Hygienic Practices:WASH HANDS BEFORE EATING AND DO NOT SMOKE WHILE
USING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Boiling Pt:B.P. Text:SEE ING 1
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Spec Gravity:1.80
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:PASTE, SHARP AROMATIC ODOR

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS AND OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT AND DIRECT SUNLIGHT.
Hazardous Decomposition Products:HEATING TO DECOMPOSITION MAY CAUSE
IRRITATING ACRID FUMES.
Conditions to Avoid Polymerization:IF HAZARDOUS POLYMERIZATION OCCURS
WHILE CONTAINED IN CLOSED CONTAINER, VIOLENT RUPTURE MAY RESULT.

Waste Disposal Methods:SMALL QTYS CAN BE REACTED WITH THE APPROPRIATE
HARDENER TO SOLIDIFY. DISPOSE OF IN ACCORDANCE WITH ALL FEDERAL,
STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.