Product ID:701 ALUMINUM PASTE, A-701
MSDS Date:10/15/1992
FSC:6810
NIIN:00N056045
MSDS Number: BWDMQ

RANDOLPH PRODUCTS CO

701 12TH ST
CARLSTADT, NJ 07072-0830
US

Emergency Phone: 201-438-3700

Info Phone: 201-438-3700

Preparer: J.H.R.

Cage: 77672

RANDOLPH PRODUCTS CO

830 CARLSTADT, NJ 07072-0830 US

Telephone: 201-438-3700

Cage: 77672

10 @ 20C.

Fraction By Weight: 100%

OSHA PEL 15 MG/M3 DUST;5 FUME

ACGIH TLV: 10 MG/M3 DUST

EPA HAZARDOUS WASTE CODE - F003. HAZARDOUS

RTECS: 9999999ZZ

LIMIT. SOLVENT VAPORS SHOULD BE REMOVED FROM LOWER

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHRONIC HEALTH EFFECTS ARE POSSIBLE
FROM LONG TERM EXPOSURE TO THIS MATERIAL, INCLUDING DRYING,
CRACKING & IRRITATION OF SKIN. REACTS W/SKIN PROTEIN & MOISTURE &
CAN CAUSE RASH, SCALING OR BLISTERING. HIGH CONCENTRATIONS MAY
CAUSE HEADACHES & DIZZINESS, ARE ANESTHETIC & MAY HAVE OTHER
CENTRAL NERVOUS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:SYSTEM EFFECTS, INCLUDING DEATH.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT. CONTACT LENS WEARERS SHOULD CONSULT PROVIDER BEFORE
HANDLING - CONSULT MD IMMED IF THERE IS EYE CONT.

First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR,
RESTORE BREATHING. CONSULT MD. SKIN:FLUSH W/WATER. EYES:FLUSH
IMMEDIATELY W/LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES.
CONSULT MD.

Flash Point Method:SCC
Flash Point:100F,38C
Lower Limits:0.9%
Upper Limits:7%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . WATER STREAM WILL SPREAD FIRE. DO NOT USE WATER HOSE
STREAM.
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, SPKS & OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN EXPOS TO
EXTREME HEAT. WATER MAY BE USED TO COOL CLSD (SUPP DATA)

Spill Release Procedures:AVOID BRTHG SOLV VAP. ENSURE ADEQ VENT. AVOID
SPKS, FLAMES & ANYTHING WHICH COULD CAUSE FIRE. ELIM SOURCE OF
SPILL IF YOU CAN DO SO W/OUT RISK BY CLOSING VALVE, PLUGGING HOLE,
ETC. APPLY ABSORB INERT MATL (SAND, DUST, VERMICULITE) TO SPILL.
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DRUMS SHOULD BE GROUNDED WHEN BEING
EMPTIED.
Other Precautions:PRECAUTIONS MUST BE TAKEN SO THAT PERSONS DO NOT
BREATHE VAPORS OR HAVE CONTACT W/EYES OR SKIN. PROTECT AGAINST
EXPOSURE TO BOTH VAPOR & SPRAY MIST.

Respiratory Protection:PROVIDE NIOSH/MSHA APPRVD RESP PROT AGAINST
FUMES GENERATED DURING BURNING. NIOSH/MSHA APPRVD RESP TYPES
SUITABLE FOR MATLS IN INGS SEC REC. NIOSH/MSHA APPRVD CHEM/MECH
FILTERS REC WHEN VENT IS RESTRI CTED.
Ventilation:SUFFICIENT VENT, IN VOL & PATTERN, SHOULD BE PROVIDED TO
KEEP AIR CONTAM BELOW CURRENT APPLIC OSHA PEL/ACGIH TLV (ING 3)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL GOGGLES & FACE SHIELD.
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
LIKELY. EYE WASH FOUNTAIN & DELUGE SHOWER MEETING ANSI DESIGN
CRITERIA
Work Hygienic Practices:REMOVE & WASH CONTAM CLTHG BEFORE REUSE. USE
NORMAL HYGIENE PRACTICES DURING & AFTER HNDLG THIS MATL.
Supplemental Safety and Health
EXPLO HAZ:CNTNRS TO PVNT PRESS BUILD-UP & POSS AUTOIGNIT/EXPLO WHEN
EXPOS TO EXTREME HEAT. REMOVE ALL NON-ESSNTL PERS FROM FIRE AREA.
VAPS IS HVR/AIR & CAN TRAVEL CONSIDERABLE DISTS TO SOURCE OF IGNIT
& FLASHBACK. SPILL PROC:CLEAN SPILL W/BRISTLE BROOMS, NON-SPARKING
TOOLS, CLEAN DRY RAGS. PROT CLTHG SHOULD BE WORN.

Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:1.52
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:THICK PASTE; TYPICAL ODOR.
Percent Volatiles by Volume:30

Stability Indicator/Materials to Avoid:YES
AVOID STRONG OXIDIZERS, ACIDS & ALKALIES.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:THERMAL DECOMPOSITION RELEASES CARBON
MONOXIDE &/OR CARBON DIOXIDE.

Waste Disposal Methods:SOAK LIQS W/SAWDUST OR RAGS & REMOVE. FLUSH
W/WATER IF POSS. AVOID SKIN CONT. DISP SHOULD BE I/A/W LOC, STATE &
FED REGS. DO NOT INCIN, CUT/WELD EMPTY CNTNRS. WHEN DISCARDED THIS
MATL IS HAZ WASTE. TR ANSFER LIQ TO CNTNRS FOR RECOVERY/DISP.(ING
2)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.