BWSST - F0201
- MSDS: BWSST
- Manufacturer: DEL PAINT CORP
- Product Name: F0201
- National Stock Number: 8010-00-616-7492
Product Identification
Product ID:F0201
MSDS Date:08/30/1993
FSC:8010
NIIN:00-616-7492
MSDS Number: BWSST
Responsible Party
OKLAHOMA CITY, OK 73117
US
Emergency Phone: 800-424-9300 CHEMTREC
Info Phone: 405-672-1431
Preparer: ONEY FLEMING
Cage: EO326
Contractor
Telephone: 405-672-1431
Cage: 39934
Ingredients
PETROLEUM DISTILLATES
CAS: 8002-05-9
RTECS: SE7449000
Fraction By Weight: 27.66%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
XYLENE (SARA 313) (CERCLA)
CAS: 1330-20-7
RTECS: ZE2190000
Fraction By Weight: 0.24%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
NON-HAZARDOUS INGREDIENTS
Fraction By Weight: 72.10%
3.25 LB/GL; 390 G/LTR
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE CONTACT: IRRITATION, REDNESS,
TEARING, AND BLURRED VISION. SKIN CONTACT: PROLONGED OR REPEATED
EXPOSURE CAN CAUSE MODERATE IRRITATION, DEFATTING AND DERMATITIS.
INHALATION: NASAL AND RESPIRATORY I RRITATION, DIZZINESS, NAUSEA,
AND HEADACHE. INGESTION: CAN CAUSE GASTROINESTINAL IRRITATION,
NAUSEA, VOMITING & NAUSEA.
Effects of Overexposure:IF TLV'S ARE EXCEEDED SKIN CONTACT PRODUCES
REDNESS. EYE CONTACT PRODUCES REDNESS AND PAIN. INHALATION GIVES
LABORED BREATHING, DULLNESS, DROWSINESS. INGESTION CAN CAUSE
ABDOMINAL PAIN AND NAUSEA.
Medical Cond Aggravated by Exposure:DISEASES OF THE RESPIRATORY SYSTEM.
First Aid
First Aid:EYE CONTACT: FLUSH WITH LARGE AMOUNTS OF WATER FOR 15
MINUTES, OCCASIONALLY LIFTING EYELIDS. SEEK MEDICAL ATTENTION. SKIN
CONTACT: REMOVE CONTAMINATED CLOTHING. WASH AFFECTED SKIN WITH SOAP
& WATER. I NHALATION: REMOVE TO FRESH AIR, ADMINISTER OXYGEN IF
NECESSARY, SEEK MEDICAL ATTENTION. INGESTION: KEEP WARM, QUIET, AND
GET MEDICAL ATTENTION. DO NOT INDUCE VOMITING.
Fire Fighting
Flash Point Method:TCC
Flash Point:115F,46C
Autoignition Temp:Autoignition Temp Text:540F
Lower Limits:1
Upper Limits:6
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, OR FOAM. WATER MAY
SPREAD FIRE, USE WATER SPRAY ONLY TO COOL CONTAINERS EXPOSED TO
FIRE.
Fire Fighting Procedures:WEAR SCBA(PRESSURE DEMAND MSHA/NIOSH APPROVED)
& FULL PROTECTIVE GEAR. USE WATER SPRAY TO COOL CONTAINERS TO
PREVENT PRESSURE BLDUP & AUTOIGNIT/EXPLOSION W/HEAT
Unusual Fire/Explosion Hazard:VAPOR HEAVIER THAN AIR & MAY TRAVEL ALONG
GROUND OR BE MOVED BY VENT & IGNITED BY PILOT LIGHT, OTHER FLAMES,
SPARK, HEATER, SMOKING OTHER REMOTE IGNITN SOURCES.
Accidental Release
Spill Release Procedures:VENTILATE THE AREA. COVER SPILL WITH INERT
ABSORBENT MATERIAL AND SHOVEL WITH NON-SPARKING TOOL INTO
CONTAINER. REMOVE CONTAINERS TO A SAFE AREA AND SEAL.
Handling
Handling and Storage Precautions:STORE IN A CLEAN DRY AREA. KEEP AWAY
FROM SPARKS, FIRE AND REMOTE IGNITION SOURCES.
Other Precautions:KEEP CONTAINER TIGHTLY CLOSED. KEEP AWAY FROM
CHILDREN. ALL EQUIPMENT SHOULD BE GROUNDED TO REDUCE STATIC
ELECTRICITY HAZARD. USE NON-SPARKING TOOLS.
Exposure Controls
Respiratory Protection:IF TLV OF THE PRODUCT OR ANY COMPONENT IS
EXCEEDED, USE A RESPIRATOR WITH APPROPRIATE CARTRIDGES (MIOSH
APPROVED). ENGINEERING OR MANAGEMENT CONTROLS SHOULD BE IMPLEMENTED
TO REDUCE EXPOSURE.
Ventilation:LOCAL EXHAUST MUST BE SUFFICIENT TO KEEP AIRBORNE VAPOR
CONCENTRATIONS BELOW THE TLV LIMIT.
Protective Gloves:CHEMICAL RESISTANT GLOVES
Eye Protection:SAFETY GLASSES WITH SIDE SHIELDS
Other Protective Equipment:SUGGEST THAT SOURCE OF CLEAN WATER BE
AVAILABLE IN WORK AREA FOR FLUSHING EYES & SKIN.WEAR IMPERVIOUS
CLOTHING AS NEEDED
Supplemental Safety and Health
Chemical Properties
Boiling Pt:B.P. Text:303F,151C
Decomp Temp:Decomp Text:752F,400C
Vapor Pres:2.58
Vapor Density:> AIR
Spec Gravity:1.23 (WATER=1)
Viscosity:77 - 86 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NO
Appearance and Odor:BLUE LIQUID WITH SLIGHT ODOR
Percent Volatiles by Volume:45.97
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:DO NOT STORE NEAR HEATED SURFACES, OPEN
FLAMES OR IGNITION SOURCES.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CARBON
DIOXIDE
Disposal
Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, AND LOCAL ENVIRONMENTAL REGULATORY CONTROLS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.