BXRMR - MBA GOLD ADHESIVE

  • MSDS: BXRMR
  • Manufacturer: MONSEY PRODUCTS CO
  • Product Name: MBA GOLD ADHESIVE
  • National Stock Number: 5610-00N060070
Product Identification

Product ID:MBA GOLD ADHESIVE
MSDS Date:05/18/1994
FSC:5610
NIIN:00N060070
MSDS Number: BXRMR

Responsible Party
MONSEY PRODUCTS CO
COLD STREAM RD
KIMBERTON, PA 19442
US

Emergency Phone: 610-933-8888

Info Phone: 610-933-8888

Cage: 6W507

Contractor
MONSEY PRODUCTS CO
368 KIMBERTON, PA 19442 US

Telephone: 610-933-8888

Cage: 6W507

Ingredients

STODDARD SOLVENT; (PETROLEUM DISTILLATE)

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 50%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM


ASPHALT

CAS: 8052-42-4

RTECS: CI9900000

OSHA PEL N/K

ACGIH TLV: 5 MG/M3; (FUME)


SOLVENT NAPHTHA (PETROLEUM), LIGHT AROMATIC; (PETROLEUM

CAS: 64742-95-6

RTECS: WF3400000

OSHA PEL N/K

ACGIH TLV: 50 PPM (MFR)

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:OVEREXPOSURE TO VAPORS CAUSES EYE
IRRITATION, BLURRED VISION, DIZZINESS, HEADACHES, EVEN
UNCONSCIOUSNESS. PROLONGED OR REPEATED SKIN CONTACT CAN CAUSE
MODERATE IRRITATION OR DERMATITIS. SWALLOWING CAN CAUSE GI IRRIT,
NAUS, VOMIT AND DIARR.ASPIR OF MATL INTO LUNGS CAN CAUSE CHEM PNEUM
WHICH CAN BE FATAL.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL:REMOVE FROM VAPS IMMED. IF OVERCOME, CALL MD. IF BRTHG
STOPPED/IRREG, START RESUSCITATION/ADMIN OXYG AS NEEDED. EYES:FLUSH
WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES, LIFTING UPPER
AND LOWER LIDS OCCASIONALLY. GET MEDICAL ATTENTION. SKIN:REMOVE
CONTAMINATED CLOTHES, AND WASH WITH WATERLESS HANDCLEANER OR SOAP
AND WATER. INGESTION:DO NOT INDUCE VOMITING.

Fire Fighting

Flash Point Method:SCC
Flash Point:105F,41C
Lower Limits:0.9%
Upper Limits:6.0%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL, WATER FOG, SPRAY.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
DURING EMER CNDTNS, OVEREXP TO DECOMP PRODS MAY CAUSE HLTH HAZ.
SYMPS MAY NOT BE IMMED APPARENT. (SUPDAT)
Unusual Fire/Explosion Hazard:DO NOT MIX/STORE W/STRONG OXIDANTS LIKE
LIQ CHLORINE/OXYG. KEEP CNTNRS TIGHTLY CLSD. CLSD CNTNRS MAY
EXPLODE WHEN EXPOSED TO EXTREME HEAT, APPLICATN TO (SUPDAT)

Accidental Release

Spill Release Procedures:REMOVE SOURCE OF IGNIT. KEEP PEOPLE AWAY.
RECOVER FREE LIQ. ADD ABSORB (SAND, EARTH, SAWDUST, ETC.) TO SPILL
AREA. AVOID BRTHG VAPS. VENT CONFINED SPACES. OPEN ALL WINDOWS &
DOORS. KEEP PRODS OUT OF S EWERS & WATERCOURSES BY
DIKING/IMPOUNDING (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:KEEP CONTAINERS CLOSED WHEN NOT IN
USE. DO NOT HANDLE OR STORE NEAR HEAT, SPARKS, FLAME OR STRONG
OXIDANTS. ADEQUATE VENTILATION REQUIRED.
Other Precautions:AVOID BRTHG VAPS. AVOID PRLNGD OR RPTD CONT W/SKIN.
REMOVE CONTAM CLTHG & LAUNDER BEFORE REUSE. REMOVE CONTAM SHOES &
THORO DRY BEFORE REUSE.

Exposure Controls

Respiratory Protection:USE NIOSH/MSHA APPRVD HYDROCARBON VAPOR CANISTER
OR SUPPLIED-AIR RESPIRATORY PROTECTION IN CONFINED OR ENCLOSED
SPACES IF NEEDED.
Ventilation:LOC EXHST:FACE VELOCITY 60FPM. SPECIAL:USE WITH ADEQUATE
VENTILATION.
Protective Gloves:CHEMICAL-RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
USE CHEM-RESIST APRON/OTHER CLTHG TO AVOID RPTD/PRLNGD SKIN CONT.
Work Hygienic Practices:WASH SKIN THOROUGHLY WITH SOAP AND WATER AFTER
CONTACT.
Supplemental Safety and Health
FIRE FIGHT PROC:OBTAIN MED ATTN. EXPLO HAZS:HOT SURFACES. SPILL
PROC:AND ADVISE AUTHORITIES.

Chemical Properties

Boiling Pt:B.P. Text:>310F,>154C
Vapor Pres:2 @ 68F
Vapor Density:HVR/AIR
Spec Gravity:0.93
Evaporation Rate & Reference:SLOWER THAN BUTYL ACETATE
Solubility in Water:NONE
Appearance and Odor:BLACK FLUID, ODOR CHARACTERISTIC OF PETROLEUM
SOLVENT.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDANTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:FUMES, SMOKE, AND CARBON DIOXIDE.
CARBON MONOXIDE IF COMBUSTION IS COMPLETE.

Disposal

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS . ASSURE CONFORMITY WITH APPLICABLE DISPOSAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.