BXSMM - TIONA RCL-7
- MSDS: BXSMM
- Manufacturer: SCM CHEMICALS
- Product Name: TIONA RCL-7
- National Stock Number: 8010-00N031231
Product Identification
Product ID:TIONA RCL-7
MSDS Date:06/25/1993
FSC:8010
NIIN:00N031231
MSDS Number: BXSMM
Responsible Party
BALTIMORE, MD 21202
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 410-931-4570
Preparer: FREDERICK M. KERSHNER
Cage: 46343
Contractor
Telephone: 301-783-1120;301-931-4570
Cage: 46343
Ingredients
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 80-99%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
SILICON DIOXIDE; (AMORPHOUS SILICA)
CAS: 112945-52-5
RTECS: VV7310000
Fraction By Weight: 10%
OSHA PEL 6 MG/M3
ACGIH TLV: 10 MG/M3
ALUMINUM HYDROXIDE
CAS: 21645-51-2
RTECS: BD0940000
Fraction By Weight: 6%
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: INERT NUISANCE DUST.
TEMPORARY DRYING EFFECT OR MILD IRRITATION OF MUCOUS MEMBRANES MAY
RESULT FROM EXCESSIVE EXPOSURE. EXPOSURE TO DUST MAY AGGRAVATE
PRE-EXISTING RESPIRATORY CONDITIONS. EYES: INERT FOREIGN BODY
HAZARD ONLY. SKIN: NON-CORROSIVE; NON-IRRITATING; NON-SENSITIZING;
MAY HAVE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: DRYING EFFECT ON SKIN. SKIN
ABSORPTION: NOT APPLIC. INGESTION: NO HAZARD DURING NORMAL
INDUSTRIAL USE. CHRONIC EFFECTS: REPEATED EXPOSURE TO PRODUCT IS
NOT ANTICIPATED TO CAUSE ANY SIGNIFICA NT ADVERSE HEALTH EFFECTS.
PRODUCT IS NOT CONSIDERED POTENTIAL CARCINOGEN.
Medical Cond Aggravated by Exposure:EXPOSURE TO DUST MAY AGGRAVATE
PRE-EXISTING RESPIRATORY CONDITIONS.
First Aid
First Aid:INGEST: CALL MD IMMEDIATELY . INHAL: REMOVE TO FRESH AIR.
EYES: FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES AND
UNTIL IRRITATION SUBSIDES. IF IRRITATION PERSISTS, SEEK MEDICAL
ATTE NTION. SKIN: WASH WITH WATER AND MILD SOAP.
Fire Fighting
Flash Point:NONE
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:PROD SUPPLIED IN GROUNDABLE SEMI-BULK
CONTAINERS MUST BE GROUNDED TO AVOID DISCHARGE OF STATIC ELEC WHILE
TRANSPORTING THE CONTAINER OR EMPTYING ITS CONTENTS.
Accidental Release
Spill Release Procedures:VACUUM OR SWEEP MATERIAL AND PLACE IN DISPOSAL
CONTAINER. PREVENT RUN-OFF FROM ENTERING STORM SEWERS AND DITCHES
WHICH LEAD TO NATURAL WATERWAYS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN DRY AREA. CAN CAUSE SLIPPERY
CONDITION IF WET.
Other Precautions:MINIMIZE BREATHING DUST & CONTACT WITH SKIN. PRODUCT
SUPPLIED IN GROUNDABLE SEMI-BULK CONTAINERS MUST BE GROUNDED TO
AVOID DISCHARGE OF STATIC ELECTRICITY WHILE TRANSPORTING CONTAINER
OR EMPTYING ITS CONTENTS.
Exposure Controls
Respiratory Protection:IF EXPOSURE GUIDELINES ARE EXCEEDED, USE OF
NIOSH/MSHA APPROVED RESPIRATOR WOULD BE REQUIRED.
Ventilation:GOOD NATRL VENT WILL BE SUFFICIENT FOR MOST CNDTNS. LOC
EXHST VENT MAY BE NEC IF AIRBORNE DUST CONC APPROACHES (SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:PERS W/SENSITIVE SKIN MAY FIND USE OF
BARRIER CREAM OR MOISTURIZER BENEFICIAL WHEN EXCESS/PRLNG CNTCT
W/SKIN IS LIKELY.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
PH: 5-9 (10% SLURRY). WASTE DISP METH: THIS MATL. (NOTE:CHEM ADDNS,
PROCESSING OR OTHERWISE ALTERING THIS MATL MAY MAKE WASTE
MANAGEMENT INFO IN MSDS INCOMPLETE, INACCURATE OR OTHERWISE
INAPPROP.) VEN T: EXPOSURE GUIDELINE.
Chemical Properties
Melt/Freeze Pt:M.P/F.P Text:3326F,1830C
Spec Gravity:3.7-4.2(H*2O=1)
pH:SUPDAT
Solubility in Water:INSOLUBLE
Appearance and Odor:FINE, WHITE, ODORLESS POWDER.
Stability
Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.
Disposal
Waste Disposal Methods:PROD IS NOT CONSIDERED HAZ WASTE UNDER FED HAZ
WASTE REGS 40 CFR 261. PLEASE BE ADVISED THAT STATE & LOC REQS FOR
WASTE DISP MAY BE MORE RESTRICTIVE OR OTHERWISE DIFFERENT FROM FED
REGS. CONSULT FED, STATE & LOC REGS REGARDING PROPER DISP OF
(SUPDAT)
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.