BXTBH - C-40, OSRAM VACUUM HOT-PRESSED INTERMETALLIC (SUPDAT)

  • MSDS: BXTBH
  • Manufacturer: EMISSIVE PRODUCTS
  • Product Name: C-40, OSRAM VACUUM HOT-PRESSED INTERMETALLIC (SUPDAT)
  • National Stock Number: 6640-00N060581
Product Identification

Product ID:C-40, OSRAM VACUUM HOT-PRESSED INTERMETALLIC (SUPDAT)
MSDS Date:11/18/1992
FSC:6640
NIIN:00N060581
MSDS Number: BXTBH

Responsible Party
EMISSIVE PRODUCTS
PORTSMOUTH AVE
EXETER, NH 03833
US

Emergency Phone: 603-772-4331

Info Phone: 603-772-4331

Cage: 0AAW3

Contractor
EMISSIVE PRODUCTS
EXETER, NH 03833 US

Telephone: 603-772-4331

Cage: 0AAW3

Ingredients

ALUMINUM NITRIDE; (TITANIUM DIBORIDE (TIB2)) (REFER ING 3)

CAS: 24304-00-5

Fraction By Weight: 50-70%

OSHA PEL N/K

ACGIH TLV: 10 MG/M3 (MFR)


BORON NITRIDE (BN)

CAS: 10043-11-5

RTECS: ED7800000

Fraction By Weight: 15-30%

OSHA PEL N/K

ACGIH TLV: 10 MG/M3 (MFR)


TITANIUM BORIDE; (ALUMINUM NITRIDE (AIN)) (REFER ING 1)

CAS: 12045-63-5

Fraction By Weight: 10-20%

OSHA PEL N/K

ACGIH TLV: 10 MG/M3 (MFR)


TUNGSTEN COMPOUND; (TUNGSTEN BORIDE) (WB)

CAS: 12007-09-9

Fraction By Weight: 0-10%

OSHA PEL N/K

ACGIH TLV: 5 MG/M3 (MFR)


USE NIOSH/MSHA APPROVED RESPIRATORS AS SPECIFIED.

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THE BOATS AS SOLD & USED AS INTENDED
ARE GENERALLY NOT CONSIDERED HAZARDOUS. IF THE MATERIALS ARE
RECYCLED OR USED IN OTHER WAYS (GRINDING, HEATING, WELDING, ETC), A
RELEASE OF DUST OR FUME COULD BE G ENERATED. PRIMARY ROUTE OF
EXPOSURE IS INHALATION OF DUST OR FUMES. THE COMPONENTS OF THE
INTERMETALLIC(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:BOAT EVAPORATION SOURCES ARE GENERALLY
CONSIDERED NONTOXIC.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL:REMOVE TO FRESH AIR. SUPPORT RESPIRATION AS NEEDED.
SEEK MEDICAL ATTENTION FOR TREATMENT, OBSERVATION & SUPPORT AS
NEEDED. SKIN:WASH AFFECTED AREA W/MILD DETERGENT & WATER. CONSULT
MD. EYE:FLUSH THOROUGHLY W/RUNNING WATER FOR AT LEAST 15 MINUTES.
CONSULT MD. INGEST:GET MEDICAL ATTENTION IF LARGE AMOUNTS HAVE BEEN
INGESTED.

Fire Fighting

Extinguishing Media:THIS MATL IS NONCOMBUST. USE APPROP EXTING AGENT
FOR SURROUND FIRE. DUST PRDCD UPON GRINDING, CUTTING, ETC OF
(SUPDAT)
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:MAY OCCUR W/CERTAIN METAL DUST FIRES. DRY
TI (FINE CHIPS, TURNINGS, SPONGE & PIECES UNDER 48 MESH) CAN BE
IGNITED BY MATCH OR SMALL SPARK.

Accidental Release

Spill Release Procedures:USE NORMAL CLEAN-UP PROCEDURES, USING WET
SWEEPING OR VACUUM, TAKING CARE TO AVOID EXCESSIVE DUSTING. REMOVE
SOURCES OF HEAT OR IGNITION. USE NONSPARKING TOOLS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:MAINTAIN GOOD HOUSEKEEPING TECHNIQUES,
SUCH AS, WET SWEEPING OR VACUUMING TO REMOVE DUST ACCUMULATION.
Other Precautions:AVOID DUST INHALATION & CONTACT OF MATERIALS W/EYES.

Exposure Controls

Respiratory Protection:USE AN APPROPRIATE NIOSH/MSHA APPROVED
RESPIRATOR IF AIRBORNE DUST CONCENTRATIONS EXCEED APPROPRIATE PEL
OR TLV. ALL APPROPRIATE REQUIREMENTS SET FORTH IN 29 CFR 1910.134
SHOULD BE MET.
Ventilation:PROVIDE SUFFICIENT GEN & LOC EXHST VENT TO MAINTAIN AIR
CONCS OF DUST BELOW PEL & TLV. IF SUCH VENT IS UNAVAIL (ING 5)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EMERG EYE WASH AND DELUGE SHOWER WHICH MEETS
ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NO:"BOAT" EVAPORATION SOURCES. MP:>4028F,>2220C.
EXTING MEDIA:CERTAIN METALS CAN PRDCE FIRE & EXPLO HAZS. DO NOT
CREATE DUST CLOUDS. DO NOT USE WATER/CO*2 EXTINGS DUE TO TI CONTE
NT. USE EXTING MEDIA APPROP TO SURROUNDFIRE. AVOID DISPERSING
POWDERED MATL INTO AIR.

Chemical Properties

Melt/Freeze Pt:M.P/F.P Text:SUPP DATA
Vapor Pres:NIL
Vapor Density:NIL
Spec Gravity:2.25-5 (H*2O=1)
Solubility in Water:INSOLUBLE
Appearance and Odor:SOLID METAL; NO ODOR.
Percent Volatiles by Volume:0

Stability

Stability Indicator/Materials to Avoid:YES
H*2O, H*2SO*4, HCL, F, CL, BR, I. REACTS VIOLENTLY W/CUPRIC OR LEAD
OXIDE WHEN HEATED. AVOID CHLORINATED SOLVENTS.

Disposal

Waste Disposal Methods:DISPOSE OF I/A/W ALL APPLICABLE FEDERAL, STATE &
LOCAL REGULATIONS. MAY HAVE SCRAP VALUE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.