Product ID:POLYESTER GLAZING PUTTY, 407
MSDS Date:09/01/1994
FSC:8030
NIIN:00N020241
MSDS Number: BXZNM

FIBRE GLASS-EVERCOAT CO INC

6600 CORNELL RD
CINCINNATI, OH 45242
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 513-489-7600

Cage: 18731

FIBRE GLASS-EVERCOAT CO INC

CINCINNATI, OH 45242 US

Telephone: 513-489-7600

Cage: 18731

4.50

CAS: 100-42-5

RTECS: WL3675000

Fraction By Weight: 20-25%

OSHA PEL 100 PPM

ACGIH TLV: 50PPM; 100 STEL, S

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (TALC

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: 50-55%

OSHA PEL 20 MPPCF Z-3

ACGIH TLV: 2 MG/M3 RDUST

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 5-10%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: CONTACT W/LIQ OR VAP MAY
RESULT IN IRRIT, REDNESS, TEARING & BLURRED VISION. SKIN: CONTACT
W/WET MATL MAY RESULT IN IRRIT OF SKIN & POSS DERM. INHAL:
EXCESSIVE INHAL OF VAPS MAY CAUSE NAS AL & RESPIRATORY IRRIT, ACUTE
NERVOUS SYS DEPRESS, FATG, WEAK, NAUS, HDCH & DIZZ. INGEST: INGEST
OF (EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE: IARC MONOGRAPHS, SUPPLEMENT,
VOL 7, PG 345, 1987: GROUP 2B. ANIMAL: NERVOUS SYSTEM.
Effects of Overexposure:HLTH HAZ: THIS MATL MAY CAUSE GI IRRIT, NAUS,
DIARR & VOMIT. ASPIR OF MATL INTO LUNGS DUE TO VOMIT MAY PRDCE
CHEMICAL PNEUMONITIS WHICH CAN BE FATAL. CHRONIC: EXCESSIVE OVEREXP
TO STYRENE HAS BEEN FOU ND TO CAUSE FOLLOWING EFTS IN LAB ANIMALS:
LIVER ABNORMALITIES, KIDNEY DAMAGE & LUNG DAMAGE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES: FLUSH IMMED W/LARGE AMOUNTS OF WATER FOR AT LEAST 15
MIN. SEE MD FOR MEDICAL TREATMENT. SKIN: IMMED WASH AFFECTED AREA
W/SOAP & WATER. REMOVE CONTAMINATED CLOTHING. CONSULT MD IF
IRRITATION DEVE LOPS. INHAL: REMOVE TO FRESH AIR. RESTORE
BREATHING. KEEP WARM & QUIET. TREAT SYMPTOMATICALLY. GET MED ATTN.
INGEST: KEEP WARM & QUIET. CONSULT MD OR POISON CONTROL CENTER
IMMED.

Flash Point:88.0F,31.1C
Lower Limits:1.1%
Extinguishing Media:FOAM, CARBON DIOXIDE AND DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . WATER MAY BE USED TO COOL CONTAINERS TO PREVENT
PRESSURE BUILD-UP WHICH MAY RUPTURE CONTAINERS.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR AND MAY
TRAVEL ALONG THE FLOOR AND BE IGNITED BY SPARKS OR FLAMES AT A
DISTANCE FROM WHERE THE MATERIAL IS BEING USED.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE
AREA. WEAR PROTECTIVE EQUIPMENT. AVOID BREATHING VAPORS. CONTAIN
SPILL. COLLECT WITH INERT ABSORBENT AND REMOVE. DISPOSE OF
PROPERLY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE MATL IN COOL, WELL-VENT AREA. DO
NOT STORE AT TEMPS ABOVE 75F. DO NOT USE/STORE NEAR HEAT, SPKS OR
OPEN FLAME. KEEP CNTNRS TIGHTLY (SUPDAT)
Other Precautions:PROD MUST BE MIXED W/CATALYST PRIOR TO USE. PLEASE
REFER TO MSDS FOR CATALYST BEFORE USING. IF PROD IS TO BE SANDED,
PEL/TLV OF 10 MG/M3 FOR NUISANCE DUSTS SHOULD BE OBSERVED. KEEP OUT
OF REACH OF CHI LDREN. AVOID CNTCT W/EYES & SKIN.

Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATORS DESIGNED TO
REMOVE PARTICULATE MATTER AND ORGANIC SOLVENT VAPORS.
Ventilation:GEN DILUTION/LOC EXHST VENT SHOULD BE PROVIDED TO KEEP
EXPOS BELOW ACCEPTABLE LIMS & TO KEEP SOLV VAPS BELOW (SUPDAT)
Protective Gloves:NEOPRENE OR NATURAL RUBBER.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:PROPER CLTHG SHOULD BE WORN TO PVNT SKIN
CNTCT. BARRIER CREAM MAY BE WORN FOR ADDNL SKIN PROT. ANSI APPRVD
EYE (SUPDAT)
Work Hygienic Practices:ALWAYS WASH HANDS AFTER USING THIS MATERIAL AND
BEFORE EATING, DRINKING OR SMOKING.
Supplemental Safety and Health
WASTE DISP METH: INFO IN OTHER SECTIONS OF MSDS. HNDLG/STOR PRECS:
CLOSED. AVOID CONTACT W/INCOMPATIBLE MATERIALS. VENT: LOWER
EXPLOSION LIMIT. OTHER PROT EQUIP: WASH & DELUGE SHOWER .

Boiling Pt:B.P. Text:293F,145C
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Spec Gravity:1.797
Evaporation Rate & Reference:SLOWER THAN ETHYL ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:25

Stability Indicator/Materials to Avoid:YES
PEROXIDES, STRONG OXIDIZERS, STRONG MINERAL ACIDS AND POLYMERIZATION
CATALYSTS.
Stability Condition to Avoid:HIGH TEMPERATURES, IGNITION SOURCES AND
CONTACT WITH INCOMPATIBLE MATERIALS.
Hazardous Decomposition Products:FUMES MAY BE PRDCED WHEN MATL IS
HEATED TO DECOMP. FUMES MAY CNTN CARBON MONOXIDE, CARBON DIOXIDE &
VARIOUS HYDROCARBS.

Waste Disposal Methods:DISPOSE OF I/A/W FED, STATE & LOC REGS. WASTE
FROM PROD MAY BE HAZ AS DEFINED UNDER RCRA 40 CFR 261. WASTE MUST
BE TESTED FOR IGNITABILITY TO DETERM APPLIC EPA HAZ WASTE NUMBERS.
BEFORE ATTEMTPING CLE AN-UP OR DISPOSING OF MATL, REFER TO HAZ
(SUPDAT)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.