Product ID:2331-ZX ORGANIC FLUX
MSDS Date:01/01/1992
FSC:3439
NIIN:00N071782
MSDS Number: CBPLC

KESTER SOLDER

515 EAST TOUHY AVE
DES PLAINES, IL 60018
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 708-297-1600

Preparer: D. BERNIER

Cage: GO345

KESTER SOLDER DIVISION OF LITTON SYSTEMS, INC.

DES PLAINES, IL 60018 US

Telephone: 847-297-1600

Cage: 75297

ISOPROPYL ALCOHOL; (2-PROPANOL) (SARA 313)

CAS: 67-63-0

RTECS: NT8050000

Fraction By Weight: 64%

OSHA PEL 400 PPM

ACGIH TLV: 400 PPM;500 STEL

GLYCEROL

CAS: 56-81-5

RTECS: MA8050000

Fraction By Weight: 11%

OSHA PEL 15 MG/M3 (MIST)

ACGIH TLV: 10 MG/M3 (MIST)

NON-HAZARDOUS INGREDIENTS (CONSISTING OF INGS 4 -6)

Fraction By Weight: BALANCE

OSHA PEL N/K

ACGIH TLV: N/K

ORGANIC ACIDS SALTS; (ORGANIC ACIDS)

OSHA PEL N/K

ACGIH TLV: N/K

SALTS

OSHA PEL N/K

ACGIH TLV: N/K

SURFACTANTS

OSHA PEL N/K

ACGIH TLV: N/K

649 G/L.

RTECS: 9999999VO

LD50 LC50 Mixture:LD50:(ORAL,RAT) 5.8 G/KG.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:PRIMARY EXPOSURE DURING SOLDERING IS
TO EVAPORATED ALCOHOL SOLVENT CONTAINING A SMALL QUANTITY OF
ORGANIC ACID. ACUTE:INHALATION:IRRITATION OF MUCOUS MEMBRANES &
PULMONARY SYSTEM. HIGH CONCENTRATION C AN CAUSE HEADACHE,
DIZZINESS, NARCOSIS & NAUSEA. SKIN CONTACT:LOCAL IRRITATION. EYE
CONTACT:IRRITATION (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:FROM CONTACT W/LIQUID & SMOKE FROM
SOLDERING. INGESTION:BURNING SENSATION IN DIGESTIVE TRACT.
CHRONIC:PRLNG/RPTD SKIN CONT CAN RSLT IN RASH. BRTHG VAPS CAN RSLT
IN HDCH, DIZZ, NARCOS & IRRIT OF MUC MEMBS. SMOKE DURING SOLDERING
CAN CAUSE PULM IRRIT & DMG. TARGET ORGANS:EYES, MUCOUS MEMBRANES &
PULM SYSTEM.
Medical Cond Aggravated by Exposure:CHEMICAL HYPERSENSITIVITY.
CONTINUED BREATHING OF HIGH CONCENTRATIONS OF ALCOHOL VAPORS CAN
AFFECT THE LIVER & CENTRAL NERVOUS SYSTEM.

First Aid:SEE MEDICAL ASSISTANCE FOR FURTHER TREATMENT, OBSERVATION &
SUPPORT IF NEEDED. EYES:FLUSH W/PLENTY OF WATER FOR AT LEAST 15
MINUTES. SKIN:WASH THOROUGHLY W/WATER. INHALATION:REMOVE VICTIM TO
FRESH AIR . INGESTION:INDUCE VOMITING & GET PROMPT MEDICAL
ATTENTION.

Flash Point Method:TOC
Flash Point:65.0F,18.3C
Lower Limits:2.5%
Upper Limits:15%
Extinguishing Media:CARBON DIOXIDE, ALCOHOL FOAM, DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . USE WATER SPRAY TO COOL FIRE EXPOSED CONTAINERS &
CONTROL VAPORS.
Unusual Fire/Explosion Hazard:MODERATE EXPLO HAZARD EXISTS WHEN EXPOSED
TO HEAT OR FLAMES. STATIC DISCHARGE. HAZ COMBUST PRODS:CARBON
MONOXIDE, CARBON DIOXIDE, ALIPHATIC ALDEHYDES & ACIDS.

Spill Release Procedures:REMOVE ALL IGNITION SOURCES. PROVIDE ADEQUATE
VENTILATION. ABSORBENTS, SUCH AS VERMICULITE, CAN BE USED TO SOAK
UP THE SPILLED LIQUID OR FLUSH AWAY W/PLENTY OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE AWAY FROM SOURCES OF IGNITION.
STORE AT TEMPERATURES ABOVE 32F(0C). OPEN CONTAINERS CAUTIOUSLY TO
ALLOW VENTING OF ANY INTERNAL PRESSURE.
Other Precautions:FLAMMABLE LIQUID.

Respiratory Protection:NOT USUALLY REQUIRED. WHEN VENTILATION IS NOT
ADEQUATE TO REMOVE SMOKE FROM THE BREATHING ZONE, A NIOSH APPROVED
CARTRIDGE TYPE RESPIRATOR SHOULD BE WORN.
Ventilation:PROVIDE ADEQUATE EXHAUST VENTILATION (GENERAL &/OR LOCAL)
TO MEET TLV REQUIREMENTS.
Protective Gloves:PLASTIC OR RUBBER GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . PLASTIC/RUBBER APRON WHEN SPLASHING
IS(SUPDAT)
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING.
Supplemental Safety and Health
HAZ DECOMP PROD:& ACIDS. OTHER PROT EQUIP:LIKELY TO OCCUR.

Boiling Pt:B.P. Text:182F,83C
Vapor Pres:30 @ 20C
Vapor Density:1.6
Spec Gravity:0.902 (H*2O=1)
pH:6.7
Evaporation Rate & Reference:1.8 (BUTYL ACETATE=1)
Solubility in Water:100% BY WT.
Appearance and Odor:PALE AMBER LIQUID W/ALCOHOL ODOR.
Percent Volatiles by Volume:75

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING MATERIALS.
Stability Condition to Avoid:SPARKS, OPEN FLAMES.
Hazardous Decomposition Products:WHEN HEATED TO SOLDERING TEMPS, SOLVS
ARE EVAPORATED & ORG MATLS MAY BE THERMALLY DEGRADED TO LIBERATE
ALDEHYDES(SUPDAT)

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS . ACCORDING TO LOCAL REGULATIONS, USUALLY BY
INCINERATION. FLUX HAS NEUTRAL PH & IS COMPLETELY BIODEGRADABLE.
EPA HAZARDOUS WASTE NO:D00 1. HAZARD CLASS:IGNITABLE WASTE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.