CCDMH - F5001 PAINT THINNER

  • MSDS: CCDMH
  • Manufacturer: DEL PAINT CORP
  • Product Name: F5001 PAINT THINNER
  • National Stock Number: 8010-00F051050
Product Identification

Product ID:F5001 PAINT THINNER
MSDS Date:08/19/1995
FSC:8010
NIIN:00F051050
MSDS Number: CCDMH

Responsible Party
DEL PAINT CORP
3105 E RENO AVE
OKLAHOMA CITY, OK 73117-6699
US

Emergency Phone: 800-866-6823/405-672-1431

Info Phone: 405-672-1431/800-866-6823

Cage: EO523

Contractor
DEL PAINT MFG
OKLAHOMA CITY, OK 73117 US

Telephone: 405-672-1431

Cage: 39934

Ingredients

LIGHT ALIPHATIC NAPHTHA, VM & P NAPHTHA, LACOLENE

CAS: 64742-89-8

Fraction By Weight: 100%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

Hazards

Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: IRRITATION TO THE MUCOUS
MEMBRANES OF THE LUNGS.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INTOXICATING, NARCOTIC, IRRITATION, REDNESS,
PAIN, LABORED BREATHING, DULLNESS, DROWSINESS, ABDOMINAL PAIN,
NAUSEA.
Medical Cond Aggravated by Exposure:DISEASES OF THE RESPIRATORY SYSTEM.

First Aid

First Aid:SKIN: SHOWER/RINSE W/PLENTY OF WATER. EYES: RINSE W/COPIOUS
AMOUNTS OF WATER. INHALATION: REMOVE TO FRESH AIR. GIVE CPR IF
NECESSARY. INGESTION: RINSE MOUTH & DRINK PLENTY OF WATER. DON'T
INDUCE VOMIT ING. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Fire Fighting

Flash Point Method:TCC
Flash Point:100F
Lower Limits:1.1
Extinguishing Media:FOAM, ALCOHOL FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:USE SCBA W/A FULL FACEPIECE OPERATED IN
PRESSURE DEMAND/OTHER POSITIVE MODE.
Unusual Fire/Explosion Hazard:VAPORS ARE > THAN AIR & TRAVEL ALONG THE
GROUND & MAY IGNITE AT A DISTANT HANDLING SITE.

Accidental Release

Spill Release Procedures:ABSORB LIQUID ON PAPER, VERMICULITE, FLOOR
ABSORBENT/OTHER ABSORBENT MATERIAL & TRANSFER TO HOOD.

Handling

Handling and Storage Precautions:STORE IN A CLEAN DRY AREA. KEEP AWAY
FROM FOOD PRODUCTS. KEEP AWAY FORM SPARKS, FIRES & REMOVE IGNITION
SOURCES.

Exposure Controls

Respiratory Protection:IF TLV IS EXCEEDED, A NIOSH/MSHA APPROVED AIR
SUPPLIED RESPIRATOR IS ADVISED. OSHA ALSO PERMITS OTHER NIOSH/MSHA
RESPIRATORS UNDER SPECIFIED CONDITIONS.
Ventilation:SUFFICIENT TO MAINTAIN EXPOSURE BELOW TLV'S.
Protective Gloves:RESISTANT/BUNA-N
Eye Protection:SPLASH GOGGLES/SAFETY GLASSES
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE. WASH HANDS & FACE BEFORE EATING.
Supplemental Safety and Health

Chemical Properties

Boiling Pt:B.P. Text:300F
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:100

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT SURFACES, OPEN FLAMES, IGNITION
SOURCES, SPARKS, STATIC DISCHARGE.
Hazardous Decomposition Products:COMBUSTION: CO2 & WATER.

Disposal

Waste Disposal Methods:DISPOSE OF WASTE MATERIAL TO A LICENSED
LANDFILL, IAW/FEDERAL, STATE & LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.