CCZCX - 111 VALVE LUBRICANT & SEALANT
- MSDS: CCZCX
- Manufacturer: DOW CORNING CORP
- Product Name: 111 VALVE LUBRICANT & SEALANT
- National Stock Number: 9150-01-270-0850
Product Identification
Product ID:111 VALVE LUBRICANT & SEALANT
MSDS Date:10/22/1993
FSC:9150
NIIN:01-270-0850
MSDS Number: CCZCX
Responsible Party
MIDLAND, MI 48686
US
Emergency Phone: 517-496-5900;800-424-9300(CHEMTREC)
Info Phone: 517-496-6000
Cage: 5D028
Contractor
Telephone: 517-496-4388
Cage: 71984
Ingredients
SILICA GEL; (SILICA, AMORPHOUS)
CAS: 112945-52-5
RTECS: VV7310000
Fraction By Weight: 9%
OSHA PEL 6 MG/M3
ACGIH TLV: 10 MG/M3
POLY (DIMETHYLSILOXANE); (POLYDIMETHYLSILOXANE)
CAS: 63148-62-9
RTECS: JJ6484500
Fraction By Weight: 83%
OSHA PEL N/K
ACGIH TLV: N/K
POLYDIMETHYLSILOXANE; (DIMETHYL SILOXANE,
CAS: 70131-67-8
Fraction By Weight: 7%
OSHA PEL N/K
ACGIH TLV: N/K
REPORTING REQUIREMENTS MAY APPLY TO SPILLS OR
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE:DIRECT CONTACT MAY CAUSE
TEMPORARY DISCOMFORT WITH MILD REDNESS AND DRYNESS SIMILAR TO
WINDBURN. SKIN:A SINGLE PROLONGED EXPOSURE (24 TO 48 HOURS) CAUSES
NO KNOWN ADVERSE EFFECTS. INHALATION :NO IRRITATION TO EYES AND
RESPIRATORY PASSAGES. NO INJURY IS LIKELY FROM RELATIVELY SHORT
EXPOSURES (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:OF <8 HOURS. INGESTION:SMALL AMOUNTS
TRANSFERRED TO THE MOUTH BY FINGERS DURING USE, ETC, SHOULD NOT
INJURE. SWALLOWING LARGE AMOUNTS MAY CAUSE DIGESTIVE DISCOMFORT.
CHRONIC:NONE KNOWN.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR.
SUPPORT BREATHING (GIVE O*2/ARTF RESP) . SKIN:FLUSH W/COPIOUS
AMOUNTS OF WATER. CALL MD . EYES:IMMEDIATELY FLUSH W/WATER FOR A T
LEAST 15 MINUTES. NOTES:TREAT SYMPTOMATICALLY.
Fire Fighting
Flash Point:>214F,>101C
Extinguishing Media:CARBON DIOXIDE (CO*2), WATER, WATER FOG (OR SPRAY),
DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . IF LARGE AMOUNT IS INVOLVED, EVACUATE AREA.
Unusual Fire/Explosion Hazard:NONE.
Accidental Release
Spill Release Procedures:COLLECTED PROD, RESIDUES & CLEANUP MATLS MAY
BE GOVERNMENTALLY REGULATED. CLEAN ANY REMAINING SLIPPERY SURFS BY
APPROP TECHNIQUES, SUCH AS: SEVERAL MOPPINGS/SWABBINGS W/APPROP
SOLVS; WASHING W/MILD, C AUSTIC DETERGENTS/SOLNS; OR HIGH PRESS
(SUPP DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:AVOID EYE CONTACT. USE REASONABLE
CARE. NO SPECIAL HANDLING OR STORAGE PRECAUTIONS.
Other Precautions:THESE PRECAUTIONS ARE FOR ROOM TEMPERATURE HANDLING.
USE AT ELEVATED TEMPERATURE, OR AEROSOL/SPRAY APPLICATIONS, MAY
REQUIRE ADDED PRECAUTIONS.
Exposure Controls
Respiratory Protection:NIOSH APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN . NO RESPIRATORY PROTECTION SHOULD BE NEEDED.
Ventilation:LOCAL EXHAUST:NONE SHOULD BE NEEDED. GENERAL
VENTILATION:RECOMMENDED.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASHING AT MEALTIME & END OF SHIFT IS ADEQUATE.
Supplemental Safety and Health
SPILL PROC:STEAM FOR LG AREAS. FOR NONSILICONES, USE TYPICAL INDUS
CLEANING MATLS. OBSERVE ANY SFTY PRECS APPLIC TO CLEANING MATL
BEING USED. SCRAPE UP & CONTAIN FOR SALVAGE/DISP OBSERVE ALL
PERSONAL PROT EQUIP RECS DESCRIBED IN FIRE FIGHTING MEASURES &
EXPOS CONTROL/PERSONAL PROT SECTIONS. LOC, STATE & FED (ING 4)
Chemical Properties
Spec Gravity:1.1
Solubility in Water:NONE
Appearance and Odor:TRANSLUCENT WHITE GREASE; ODORLESS.
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIAL CAN CAUSE A REACTION.
Stability Condition to Avoid:NONE.
Hazardous Decomposition Products:SILICON DIOXIDE, CARBON OXIDES &
TRACES OF INCOMPLETELY BURNED CAROBN COMPOUNDS, FORMALDEHYDE.
Disposal
Waste Disposal Methods:DISPOSAL OF COLLECTED PRODUCT, RESIDUES &
CLEANUP MATLS MAY BE GOVERNMENTALLY REGULATED. OBSERVE ALL APPLIC
LOCAL, STATE & FEDERAL MANAGEMENT REGULATIONS. CALL MFR
ENVIRONMENTAL MGMT (517)496-6315, IF MORE INFO IS DESIRED.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.