Product ID:ULTRATHERM BLOWING WOOL
MSDS Date:08/31/1995
FSC:5640
NIIN:00F027458
MSDS Number: CCZLV

CERTAIN-TEED CORP

750 E SWEDESFORD RD
VALLEY FORGE, PA 19482
US

Emergency Phone: 215-341-7677AM/215-341-7000PM

Info Phone: 215-341-7677AM/215-341-7000PM

Cage: 89638

CERTAIN-TEED CORP

860 VALLEY FORGE, PA 19482 US

Telephone: 215-341-7806

Cage: 89638

GLASS OXIDE, FIBER GLASS WOOL, LEAD BOROSILICATE GLASS

CAS: 65997-17-3

RTECS: LK3651000

Fraction By Weight: 78-97%

OSHA PEL 15 MG/CUM

ACGIH TLV: 10 MG/CUM

PHENOL, UREA, FORMALDEHYDE RESIN

CAS: 25104-55-6

Fraction By Weight: 3-7%

OIL PETROLEUM DISTILLATES, SOLVENT-DEWAXED HEAVY PARAFFINIC

CAS: 64742-65-0

RTECS: PY8038500

Fraction By Weight: 0.5-1.5%

OSHA PEL 5 MG/CUM

ACGIH TLV: 5 MG/CUM

SOLVENT REFINED HYDROTREATED HEAVY PARAFFINIC DISTILLATE,

CAS: 64742-54-7

RTECS: PY8035500

OSHA PEL 5 MG/CUM (MIST)

Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: TEMPORARY UPPER
RESPIRATORY IRRITATION, POSSIBLE CAUSE OF CANCER. SKIN/EYES:
TEMPORARY IRRITATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION.
Medical Cond Aggravated by Exposure:PRE-EXISTING MECHANICAL IRRITATION.

First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: FLUSH WELL W/RUNNING
WATER FOR 15 MINS. SKIN: CLEANSE W/SOAP & WARM WATER. OBTAIN
MEDICAL ATTENTION IN ALL CASES. INFORMATION FOR MEDICAL
PRACTITIONERS: SKIN IRR ITATION RESPONDS WELL TO MILD
HYDROCORTISONE CREAM.

Flash Point:NON-COMBUSTIBLE
Extinguishing Media:USE EXTINGUISHING MEDIA APPROPRIATE FOR SURROUNDING
FIRE.
Fire Fighting Procedures:TREAT AS RESIDENTIAL BUILDING MATERIALS. CARE
SHOULD BE TAKEN NOT TO LEAVE FACING EXPOSED WHEN WORKING CLOSE TO
AN OPEN FLAME.
Unusual Fire/Explosion Hazard:THE BINDER & KRAFT FACING MAY EMIT TOXIC
FUMES & SMOKE. FACINGS ON THESE PRODUCTS MAY BURN.

Spill Release Procedures:VACUUM DUST DEPOSITS. CLEAN AREA W/VACUUM/WET
METHODS.

Handling and Storage Precautions:STORE UNDER COVER TO PROTECT PRODUCT.

Respiratory Protection:WEAR NIOSH/MSHA APPROVED RESPIRATORS WHEN
HANDLING & APPLYING FIBER GLASS INSULATION PRODUCTS, USE <10 TIMES
3M 8710/3M 9900 RESPIRATOR/EQUIVALENT/<50 TIMES MSA ULTRA TWIN FULL
FACE RESPIRATOR W/TYPE H FILTER (HEPA).
Ventilation:GENERAL/LOCAL EXHAUST TO CONTROL AIRBORNE DUST LEVELS BELOW
EXPOSURE LIMITS.
Protective Gloves:REQUIRED
Eye Protection:GOGGLES/SAFETY GLASSES/FACE MASK
Other Protective Equipment:LONG SLEEVES, CAP.
Work Hygienic Practices:WASH WORK CLOTHES SEPERATELY & RINSE WASHER
AFTER USE. BATHE W/SOAP & WARM WATER.
Supplemental Safety and Health
APPERANCE & ODOR: SOLID YELLOW FIBERS ASSEMBLED INTO BLANKETS/LOOSE
FILL, FACED W/KRAFT, ALUMINUM FOIL/A COMBINATION. SPECIFIC GRAVITY
INFORMATION IS FOR GLASS.

Melt/Freeze Pt:M.P/F.P Text:2200F
Spec Gravity:2.5
Solubility in Water:SLIGHT
Appearance and Odor:(SEE SUPP)

Stability Indicator/Materials to Avoid:YES
HYDROFLUORIC ACID.
Stability Condition to Avoid:MECHANICAL IMPACT, STATIC DISCHARGE.
Hazardous Decomposition Products:PRODUCT ISN'T SENSITIVE TO MECHANICAL
IMPACT/STATIC DISCHARGE.

Waste Disposal Methods:SCRAP METAL SHOULD BE DISPOSED OF IN A SANITARY
LANDFILL IAW/FEDERAL, STATE & LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.