CDKYN - POLYMER 1160X
- MSDS: CDKYN
- Manufacturer: BETZ LABORATORIES INC
- Product Name: POLYMER 1160X
- National Stock Number: 6810-00N048206
Product Identification
Product ID:POLYMER 1160X
MSDS Date:04/25/1995
FSC:6810
NIIN:00N048206
MSDS Number: CDKYN
Responsible Party
TREVOSE, PA 19053-6783
US
Emergency Phone: 800-877-1940
Info Phone: 215-355-3300
Cage: 0TC96
Contractor
Cage: 0TC96
Ingredients
NON-HAZARDOUS INGREDIENTS
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: SKIN/EYES: MAY CAUSE SLIGHT
IRRITATION. INHALATION: DUSTS MAY CAUSE IRRITATION TO UPPER
RESPIRATORY TRACT. CHRONIC: NO EVIDENCE OF POTENTIAL CHRONIC
EFFECTS.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:MAY CAUSE REDNESS OR ITCHING OF SKIN.
Medical Cond Aggravated by Exposure:NOT KNOWN.
First Aid
First Aid:SKIN: REMOVE CONTAM CLTHG. WASH EXPOSED AREA W/LGE QTY OF
SOAP SOLN/WATER FOR 15 MIN. EYES: IMMED FLUSH W/WATER FOR AT LEAST
15 MIN. IMMED CONT MD FOR ADDNL TREATMENT. INHAL: REMOVE TO FRESH
AIR. APPL Y APPROP FIRST AID TREATMENT AS NEC. INGEST: DO NOT FEED
ANYTHING BY MOUTH TO AN UNCON/CONVULSIVE VICTIM. DO NOT INDUCE
VOMIT. IMMED CONT MD. DILUTE CONTENTS OF STOM USING 3-4 GLASSES OF
MILK/WATER.
Fire Fighting
Flash Point Method:PMCC
Flash Point:>200F,>93C
Extinguishing Media:DRY CHEMICAL, CARBON DIOXIDE, FOAM OR WATER.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.
Accidental Release
Spill Release Procedures:VENTILATE AREA, USE SPECIFIED PROTECTIVE
EQUIPMENT. SWEEP UP AND PLACE IN WASTE DISPOSAL CONTAINER. FLUSH
AREA WITH WATER. WET AREA MAY BE SLIPPERY. SPREAD SAND/GRIT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP CONTAINERS CLOSED WHEN NOT IN
USE. KEEP DRY.
Other Precautions:NORMAL CHEMICAL HANDLING.
Exposure Controls
Respiratory Protection:USE PROT EQUIP I/A/W 29 CFR 1910.132.134. USE
RESPS W/IN USE LIMITATIONS/ELSE USE NIOSH APPRVD SUPPLIED AIR
RESPS. IF VENT IS INADEQ/SIGNIFICANT PROD EXPOS IS LIKELY, USE
NIOSH APPRVD RESP W/DUST/MIST FILTERS.
Ventilation:ADEQUATE VENTILATION TO MAINTAIN DUST CONCENTRATIONS BELOW
THE EXPOSURE LIMIT OF 10MG/M3 (PEL/TLV) FOR NUISANCE DUSTS.
Protective Gloves:RUBBER GLOVES RECOMMENDED.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:EMERGENCY EYEWASH AND DELUGE SHOWER MEETING
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH OFF AFTER EACH USE. REPLACE AS NECESSARY.
Supplemental Safety and Health
PH: 0.5% SOLUTION (APPROX) 4.2.
Chemical Properties
Vapor Pres:<0.1
Vapor Density:<1.00
pH:SUPDAT
Evaporation Rate & Reference:<1.00 (ETHER=1)
Solubility in Water:2.0
Appearance and Odor:WHITE POWDER, NO ODOR
Stability
Stability Indicator/Materials to Avoid:YES
MAY REACT WITH STRONG OXIDIZERS.
Stability Condition to Avoid:DO NOT CONTAMINATE. BETZ TANK CLEAN-OUT
CATEGORY 'A'.
Hazardous Decomposition Products:THERMAL DECOMPOSITION (DESTRUCTIVE
FIRES) YIELDS ELEMENTAL OXIDES.
Disposal
Waste Disposal Methods:WATER CONTAM W/PROD MAY BE SENT TO SANITARY
SEWER TREATMENT FACILITY, I/A/W ANY LOC AGREEMENT, PERMITTED WASTE
TREATMENT FACILITY/DISCHARGED UNDER NPDES PERMIT. PROD (AS IS):
INCIN/BURY IN APPRVD LAND FILL. DISP OF I/A/W LOC, STATE & FED REGS
.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.