Product ID:N-5544 BLUE-GRAY SILICONE ENAMEL
MSDS Date:01/21/1997
FSC:8010
NIIN:01-374-8954
MSDS Number: CDVWS

NILES CHEMICAL PAINT CO

225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377

Preparer: MIKE LICHATOWICH

Cage: 02388

NILES CHEMICAL PAINT

307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

HIGH SOLIDS SILICONE (VAPOR PRESSURE 1.5 MM HG @ 20C)

Fraction By Weight: 34.0%

MINERAL SPIRITS

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 16.0%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

#100 SOLVENT (VAPOR PRESSURE 4.4 MM HG @ 20C)

CAS: 64742-95-6

Fraction By Weight: 9.0%

OSHA PEL 50 PPM

ACGIH TLV: 50 PPM, STEL 50 PPM

COBALT COMPOUNDS (AS CO) (SARA 313)

CAS: 7440-48-4

RTECS: GF8750000

Fraction By Weight: <1.0%

OSHA PEL 0.1 MG/M3

ACGIH TLV: 2 MG/M3

PROPRIETARY INGREDIENTS

Fraction By Weight: BALANCE

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 5.0%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE: SEVERE IRRIT, TEAR, RED, BLURRED
VISION. SKIN: RED, IRRIT, DEFATTING (DERMATITIS). INHAL: NASAL &
RESPIRATORY IRRIT, CNS DEPRESSION (DIZZY, DROWSY, WEAKNESS,
FATIGUE, CONFUSION) NAUSEA, HEADACHE, VERTIGO, UNCONSCIOUSNESS,
ASPHYXIATION. INGEST: GI IRRIT, ABDOMINAL PAIN, NAUSEA, VOMIT,
DIARRHEA, BLINDNES, DEATH.
Effects of Overexposure:CHRONIC: LIVER, KIDNEYS, CNS. PROLONGED
EXPOSURE TO SOLVENTS MAY CAUSE CHRONIC HEALTH EFFECTS. TARGET
ORGANS: LIVER KIDNEY, CNS, SKIN, EYES, RESPIRATORY SYSTEM, CNS.

First Aid:INHAL: MOVE TO FRESH AIR. GIVE ARTIF RESP IF NEEDED. SKIN:
FLUSH W/PLENTY H2O. REMOVE CONTAM CLOTHES/SHOES WASH/DECONTAMINATE
BEFORE REUSE. EYE: FLUSH W/LARGE AMOUNTS WATER >15 MINUTES. LIFT
LIDS. ING EST: INDUCE VOMIT (2 GLASSES WATER & FINGER DOWN THROAT).
NEVER GIVE ANYTHING BY MOUTH TO UNCONSCIOUS PERSON. GET MED AID IN
ALL CASSES.

Flash Point Method:TCC
Flash Point:107F,42C
Lower Limits:0.8
Upper Limits:36.0
Extinguishing Media:DRY CHEMICAL, FOAM, CO2
Fire Fighting Procedures:WEAR SCBA W/FULL FACPIECE (POSITIVE PRESSURE
MODE) & FULL PROTECT CLOTH. USE WATER TO COOL CLOSED CNTNR TO
PREVENT PRESSURE BLDUP/AUTO IGNIT/EXPLOSION W/HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNR CLSD.VAPOR HEAVY,TRAVEL ON
GRND TO IGNIT.KEEP FROM IGNITS. CLSD CNTNRS EXPLODE W/HEAT. APPLIC
TO HOT SRFCS REQ SPCL CAUTN. DECOMP PRODUCT-HEALTH HZD.

Spill Release Procedures:ELIMINATE IGNIT SOURCE. MINIMIZE VAPOR
BREATHING. AVOID SKIN CONTACT. SMALL: ABSORB/SHOVEL RECLAIMED
LIQUID INTO RECOVERY/SALVAGE DRUMS FOR DISPOSAL. LRG: DIKE/RECLAIM
INTO RECOVERY/SALVAGE DRUMS OR T ANK TRUCK.

Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURE AREA
OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT IN USE.
AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMTPY DRUMS. SHOCK FROM DROPPING
MAY SPLIT CONTAINER.

Respiratory Protection:WEAR AN APPROPRIATE PROPERLY FITTED HALF-MASK OR
FULL FACEPIECE RESPIRATOR (NIOSH/MSHA) DURING/AFTER APPLICATION
UNLESS AIR MONITORING DEMONSTRATES VAPOR/MIST LEVELS BELOW
APPLICABLE LIMITS. FOLLOW RE SPIRATOR MFR'S DIRECTIONS FOR USE.
Ventilation:KEEP BELOW TLV/PEL. REMOVE DECOMPOSITION PRODUCTS FORMED
DURING WELDING/FLAME CUTTING OF COATED SURFACES.
Protective Gloves:CHEM RESISTANT (NITRILE/VITON) GLOVES
Eye Protection:CHEM GOGGLES,SAFETY GLASSES,FACE SHIELD
Other Protective Equipment:DON'T WEAR CONTACT LENSES WHILE WORKING WITH
PRODUCT.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING, OR USING
RESTROOM.
Supplemental Safety and Health
NK

Boiling Pt:B.P. Text:146 TO 398F
Decomp Temp:Decomp Text:NOT EST.
Vapor Density:> AIR
Spec Gravity:1.263
pH:NA
VOC Grams/Liter:2.79
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:YES
Appearance and Odor:LIQUID, ODOR OF SOLVENTS
Percent Volatiles by Volume:41.25
Corrosion Rate:MINIMAL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS,STRONG ACIDS
Stability Condition to Avoid:HIGH TEMPERATURES
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE.
Conditions to Avoid Polymerization:HIGH TEMPERATURES

Waste Disposal Methods:IN ACCORDANCE WITH APPLICABLE LOCAL, STATE, AND
FEDERAL REGULATION. EPA HAZARDOUS WASTE CODE: D001 (IGNITABLE)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.