CDZHR - SIL 95 BA-40 PE RESIN(EZ CAST) 101082 BRW 33,PLASTIC CASTING
- MSDS: CDZHR
- Manufacturer: INTERPLASTIC CORP SUB OF PHILLIPS PETROLEUM CO
- Product Name: SIL 95 BA-40 PE RESIN(EZ CAST) 101082 BRW 33,PLASTIC CASTING
- National Stock Number: 6850-00D006801
Product Identification
Product ID:SIL 95 BA-40 PE RESIN(EZ CAST) 101082 BRW 33,PLASTIC CASTING
MSDS Date:04/30/1996
FSC:6850
NIIN:00D006801
MSDS Number: CDZHR
Responsible Party
MINNEAPOLIS, MN 55413-1714
US
Emergency Phone: 612-481-6860/800-424-9300(CHEMTREC)
Info Phone: 612-481-6860/FAX 612-331-4634
Cage: 16881
Contractor
Telephone: 612-331-6850
Cage: 9F361
Ingredients
UNSATURATED POLYESTER BASE RESIN
Fraction By Weight: 62 - 64%
STYRENE MONOMER (SARA 313)/STYRENE
CAS: 100-42-5
RTECS: WL3675000
Fraction By Weight: 36 - 38%
OSHA PEL 100 PPM
ACGIH TLV: S,50PPM/100STEL;9596
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
Hazards
LD50 LC50 Mixture:LD50 (ORAL, RAT) IS UNKNOWN.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:TARGET ORGANS:EYE, SKIN, CNS,
RESPIRATORY & GI TRACTS. ACUTE- MAY CAUSE SEVERE EYE IRRITATION &
DEFATTING OF SKIN. HARMFUL IF INHALED OR INGESTED. INHALATION MAY
CAUSE IRRITATION & CNS EFFECTS. INGEST ION MAY CAUSE GI IRRITATION,
VOMITING. ASPIRATION HAZARD. CHRONIC- MAY CAUSE DERMATITIS.
Explanation of Carcinogenicity:CONTAINS STYRENE.
Effects of Overexposure:SEVERE EYE IRRITATION, TEARING, REDNESS, DRYING
AND CRACKING OF SKIN, NAUSEA, VOMITING, DIARRHEA, DIZZINESS,
HEADACHE, DROWSINESS, WEAKNESS, FATIGUE, UNCONSCIOUSNESS,
DERMATITIS
Medical Cond Aggravated by Exposure:PERSONS WITH A HISTORY OF AILMENTS
OR WITH A PRE-EXISTING DISEASE INVOLVING THE EYES, SKIN, CNS OR
RESPIRATORY TRACT MAY BE AT INCREASED RISK FROM EXPOSURE.
First Aid
First Aid:GET MEDICAL HELP IF SYMPTOMS PERSIST. INHALED:MOVE TO FRESH
AIR. PROVIDE CPR/OXYGEN IF NEEDED. EYES:IMMEDIATELY FLUSH WITH
WATER FOR 15 MINUTES, HOLDING EYELIDS OPEN. CALL PHYSICIAN.
SKIN:WASH WITH SO AP & WATER. ORAL:DO NOT INDUCE VOMITING. GET
MEDICAL ATTENTION IMMEDIATELY. NEVER GIVE ANYTIHING BY MOUTH TO AN
UNCONSCIOUS PERSON.
Fire Fighting
Flash Point:88.0F,31.1C
Lower Limits:1.1
Upper Limits:6.1
Extinguishing Media:USE CARBON DIOXIDE, REGULAR FOAM/DRY CHEMICAL.
DIRECTLY SPRAYING WATER/FOAM ONTO BURNING LIQUID MAY CAUSE
FROTHING.
Fire Fighting Procedures:WEAR FULL PROTECTIVE CLOTHING AND
NIOSH-APPROVED SELF-CONTAINED BREATHING APPARATUS WITH FULL
FACEPIECE OPERATED IN POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:VAPOR IS HEAVIER THAN AIR AND CAN TRAVEL
CONSIDERABLE DISTANCE TO A SOURCE OF IGNITION AND FLASH BACK.
CONTAINERS MAY RUPTURE DUE TO VAPOR PRESSURE BUILDUP.
Accidental Release
Spill Release Procedures:WEAR PROTECTIVE EQUIPMENT. ELIMINATE SOURCES
OF IGNITION. VENTILATE AREA. PICK UP SPILL WITH NON-FLAMMABLE
ABSORBENT SUCH AS SAND, VERMICULITE/EXPLOSION-PROOF PUMP. GROUND
ALL HANDLING EQUIPMENTS. PRE VENT LIQUID FROM ENTERING SEWERS OR
WATERWAYS.
Neutralizing Agent:NOT RELEVANT
Handling
Handling and Storage Precautions:STORE IN COOL, VENTILATED AREA, AWAY
FROM SOURCES OF IGNITION AND INCOMPATIBLES. BOND & GROUND
CONTAINERS WHEN TRANSFERRING LIQUID.
Other Precautions:AVOID BREATHING VAPORS. DO NOT GET IN EYES, ON SKIN
OR ON CLOTHING. WASH THOROUGHLY AFTER HANDLING. REMOVE CONTAMINATED
CLOTHING. LAUNDER BEFORE REUSE. KEEP OUT OF REACH OF CHILDREN.
EMPTY CONTAINER R ETAINS RESIDUE. FOLLOW LABEL INSTRUCTION
Exposure Controls
Respiratory Protection:NONE NORMALLY REQUIRED. IF TLV IS EXCEEDED OR
FOR SYMPTOMS OF OVER EXPOSURE, WEAR NIOSH-APPROVED RESPIRATOR OR
AIR-PURIFYING RESPIRATOR. IN EMERGENCY, WEAR A NIOSH-APPROVED
POSITIVE-PRESSURE SELF-CONT AINED BREATHING APPARATUS.
Ventilation:MECHANICAL (GENERAL AND/OR LOCAL EXHAUST, EXPLOSION-PROOF)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:NITRILE, PVC, LATEX
Eye Protection:SAFETY GLASSES/CHEMICAL SPLASH GOGGLES
Other Protective Equipment:EYE WASH STATION, SAFETY SHOWER, WORK
CLOTHING AND APRON AS REQUIRED.
Work Hygienic Practices:OBSERVE GOOD INDUSTRIAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. WASH THOROUGHLY BEFORE EATING,
DRINKING/SMOKING.
Supplemental Safety and Health
Chemical Properties
HCC:F4
NRC/State Lic Num:NOT RELEVANT
Boiling Pt:B.P. Text:293F,145C
Melt/Freeze Pt:M.P/F.P Text:NOT KNOWN
Vapor Pres:4.3 @ 68F
Vapor Density:3.6
Spec Gravity:1.0 - 1.2
Evaporation Rate & Reference:<1 (ETHER=1)
Appearance and Odor:UNSATURATED POLYESTER RESIN (LIQUID)
Percent Volatiles by Volume:36- 38
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG MINERAL ACIDS, STRONG ALKALIS
Stability Condition to Avoid:HEAT (>38C/>100F), SPARKS, HOT SURFACES,
STATIC ELECTRICITY, OPEN FLAMES AND OTHER SOURCES OF IGNITION, AIR
EXPOSURE
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
VARIOUS HYDROCARBONS, ORGANIC ACIDS
Disposal
Waste Disposal Methods:CONSULT LOCAL AUTHORITIES. DISPOSAL MUST BE MADE
IN ACCORDANCE WITH APPLICABLE FEDERAL, STATE AND LOCAL LAWS AND
REGULATIONS. RECYCLING, REUSE OR INCINERATION IS RECOMMENDED.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.