Product ID:FULTHANE HIGH SOLIDS ACCELERATOR, 483-54
MSDS Date:02/28/1997
FSC:8010
NIIN:00N081131
MSDS Number: CFZRP

E I DUPONT DE NEMOURS & CO INC

1007 MARKET ST
WILMINGTON, DE 19898
US

Emergency Phone: 800-441-3637;800-424-9300(CHEMTREC)

Info Phone: 800-441-7515

Cage: 0ERJ7

E.I. DUPONT DE NEMOURS & CO

WILMINGTON, DE 19898 US

Telephone: 800-441-7515;800-441-9442

Cage: 18873

STANNANE, DIBUTYLBIS (LAUROYLOXY)-; (DIBUTYLTIN DILAURATE)

CAS: 77-58-7

RTECS: WH7000000

Fraction By Weight: 100%

OSHA PEL 0.1 MG SN/M3 SKIN

ACGIH TLV: 0.1 MG SN/M3

7.00 @ 20C

CAS: 123-54-6

RTECS: SA1925000

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHAL: MAY CAUSE NOSE & THROAT
IRRIT. MAY CAUSE NERV SYS DEPRESS W/HDCH, DIZZ, NAUS, STAG GAIT,
CONFUSION, UNCON. RPTS HAVE ASSOC RPTD & PRLNG OVEREXP TO SOLVS
W/PERM BRAIN & NERV SYS DMG. EYES : MAY CAUSE IRRIT/BURNING. SKIN:
RPTD/PRLNG LIQ CONT MAY CAUSE IRRIT W/DISCOMFORT & DERM. (EFTS OF
OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: DIBUTYL TIN DILAURATE: CAUSES EYE
CORR & PERM INJURY. CONT MAY CAUSE SKIN BURNS. CAN BE ABSORBED THRU
SKIN IN HARMFUL AMTS. 4-PENTANEDIONE: CAN BE ABSORBED THRU SKIN IN
HARMFUL AMTS. RPTD EX POS TO HIGH CONCS HAS CAUSED ADVERSE HLTH
EFTS IN LAB ANIMALS. THESE EFTS INVOLVED CNS, IMMUNE SYS, & RED
(SUP DAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHALATION: REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE
ARTIFICIAL RESPIRATION, PREFERABLY MOUTH-TO-MOUTH. IF BREATHING
DIFFICULTY PERSISTS/OCCURS LATER, CONSULT MD. EYES: IMMEDIATELY
FLUSH WITH PLENT Y OF WATER FOR AT LEAST 15 MINUTES; CALL MD. SKIN:
WASH WITH SOAP & WATER. IF IRRITATION OCCURS, CONTACT MD.
INGESTION: GI DISTRESS. CALL MD IMMEDIATELY & HAVE NAMES OF
INGREDIENTS AVAILABLE.

Flash Point Method:CC
Flash Point:>73F,>23C
Lower Limits:2.4%
Upper Limits:11.6%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . WATER FROM FOG NOZZLES MAY BE USED TO PREVENT PRESSURE
BUILD-UP.
Unusual Fire/Explosion Hazard:WHEN HEATED ABOVE FLASH POINT, EMITS
FLAMMABLE VAPS WHICH, WHEN MIXED W/AIR, CAN BURN/BE EXPLO. FINE
MIST/SPRAYS MAY BE FLAMMABLE AT TEMPS BELOW FLASH POINT.

Spill Release Procedures:VENTILATE AREA. REMOVE SOURCES OF IGNITION.
PREVENT SKIN CONTACT AND BREATHING OF VAPOR. CONFINE AND REMOVE
WITH INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP AWAY
FROM HEAT, SPARKS, AND FLAME. CLOSE CONTAINER AFTER EACH USE.
GROUND CONTAINERS WHEN POURING.
Other Precautions:DO NOT STORE ABOVE 120F. DO NOT SAND, FLAME CUT,
BRAZE OR WELD DRY COATING WITHOUT A NIOSH APPROVED RESPIRATOR OR
APPROPRIATE VENTILATION.

Respiratory Protection:DO NOT BREATHE VAPS/MISTS. WEAR PROPERLY FITTED
VAP/PARTICULATE RESP APPRVD BY NIOSH (TC-23C) FOR USE W/PAINTS
DURING APPLICATION & UNTIL ALL VAPS & SPRAY MISTS ARE EXHAUSTED.
FOLLOW RESP MFR'S DIRECT IONS FOR RESP USE.
Ventilation:PROVIDE SUFFICIENT VENT IN VOL & PATTERN TO KEEP
CONTAMINANTS BELOW APPLIC OSHA REQS & OTHER SUGGESTED EXPOS LIMITS.
Protective Gloves:NEOPRENE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
COVERALLS REC. DO NOT USE PROT CREAMS FOR PROT. (SUP DAT)
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
EATING OR SMOKING.
Supplemental Safety and Health
EFTS OF OVEREXP: BLOOD CELL FORMING SYS. NO EFT WAS SEEN AT 100 PPM.
ODOR IS DISAGREABLE AT A FEW PPM. INGEST MAY RSLT IN GASTRIC
DISTURB. OTHER PROT EQUIP: MAY BE USED FOR EASE OF CLEAN UP.

Boiling Pt:B.P. Text:>135F,>57C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
VOC Grams/Liter:8.
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SYSTEM IN WATER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER
Percent Volatiles by Volume:99.0

Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORESEEABLE.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
SMOKE, OXIDES OF HEAVY METALS REPORTED IN INGREDIENTS SECTION.

Waste Disposal Methods:DO NOT ALLOW MATERIAL TO CONTAMINATE GROUND
WATER SYSTEMS. INCINERATE ABSORBED MATERIAL IN ACCORDANCE WITH
FEDERAL, STATE AND LOCAL REQUIREMENTS. DO NOT INCINERATE IN CLOSED
CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.