CHXQD - QD ENAMEL UNDERCOATER, 6-6
- MSDS: CHXQD
- Manufacturer: PPG INDUSTRIES INC
- Product Name: QD ENAMEL UNDERCOATER, 6-6
- National Stock Number: 8010-00-537-6864
Product Identification
Product ID:QD ENAMEL UNDERCOATER, 6-6
MSDS Date:11/22/1996
FSC:8010
NIIN:00-537-6864
Status Code:A
MSDS Number: CHXQD
Responsible Party
ALLISON PARK, PA 15101
US
Emergency Phone: 304-843-1300
Info Phone: 412-492-5555
Cage: DO542
Contractor
Telephone: 412-492-5555
Cage: DO542
Ingredients
CALCIUM CARBONATE
CAS: 1317-65-3
RTECS: EV9580000
Fraction By Weight: 50-<60%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
TITANIUM DIOXIDE
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 10-<20%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
SILICA, CRYSTALLINE - QUARTZ; (QUARTZ)
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: 0.1-<1%
OSHA PEL N/K
ACGIH TLV: 0.1 MG/M3 RDUST
STODDARD SOLVENT; (NAPHTHA)
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 20-<30%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
2-BUTANONE, OXIME; (METHYL ETHYL KETOXIME)
CAS: 96-29-7
RTECS: EL9275000
Fraction By Weight: 0.1-<1%
OSHA PEL N/K
ACGIH TLV: N/K
IGNIT SOURCES (IE, PILOT LIGHTS, ELEC MOTORS,
RTECS: 9999999ZZ
FLASH BACK. DO NOT SMOKE WHILE USING PROD. KEEP
RTECS: 9999999ZZ
EXPLODE WHEN OVERHEATED. DO NOT APPLY TO HOT SURFS.
RTECS: 9999999ZZ
MW POLYMER FRACTIONS. EXTREME HEAT
RTECS: 9999999ZZ
SILICOSIS. THESE EFTS ARE ASSOC W/BRTHG
RTECS: 9999999ZZ
CONTAINS TITANIUM DIOXIDE. ANIMALS INHALING MASSIVE
RTECS: 9999999ZZ
PIGMENT INDICATE NO INCREASED RISK OF CANCER FROM
RTECS: 9999999ZZ
FROM COATINGS IS VERY LIMITED. SINCE OVEREXPS ARE
RTECS: 9999999ZZ
THIS PROD CONTAINS METHYL ETHYL KETOXIME. STUDIES
RTECS: 9999999ZZ
IN SPLEEN & KIDNEY, ANEMIA, LIVER CANCER &
RTECS: 9999999ZZ
MIST, REMOVE TO FRESH AIR. APPLY ARTF RESP
RTECS: 9999999ZZ
ANY TYPE OF OVEREXP OR SYMPS OF OVEREXP OCCUR
RTECS: 9999999ZZ
CONTROL CENTER, EMERGENCY ROOM OR MD IMMED; HAVE
RTECS: 9999999ZZ
EMPTY CNTNRS FOR DISPOSAL. ONLY SPILLED MATL &
RTECS: 9999999ZZ
AVOID FREE FALL OF LIQUIDS IN EXCESS OF A FEW
RTECS: 9999999ZZ
INSTRUCTIONS & LITERATURE CAREFULLY TO DETERMINE
RTECS: 9999999ZZ
EFFECTIVE, ITS LIMITATIONS & HOW IT IS TO BE
RTECS: 9999999ZZ
SUGGESTED EXPOSURE LIMITS, LEL BELOW STATED LIMIT &
RTECS: 9999999ZZ
BEEN DONE ON PROT CLTHG FOR PROD. RECOMS
RTECS: 9999999ZZ
FOR FREQUENT CONTACT OR TOTAL IMMERSION, CONTACT
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:EFTS OF OVEREXP FROM: INGEST: MAY BE
HARMFUL IF SWALLOWED. EYE CNTCT: CAUSES EYE IRRIT. SKIN CNTCT: MAY
CAUSE SLIGHT SKIN IRRIT. INHAL: VAP &/OR SPRAY MIST MAY BE HARMFUL
IF INHALED. RPTD EXPOS TO HIG H VAP CONCS MAY CAUSE IRRIT OF RESP
SYS& PERM BRAIN & NERVOUS SYS DMG. SIGNS & SYMPS OF OVEREXP: EYE
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:QUARTZ, SILICA-CRYSTALLINE: IARC MONO,
VOL 68, 1997:GROUP 1. NTP 7TH ANNUAL REPORT ON CARCINS, 1994:ANTIC
TO BE CARCIN.
Effects of Overexposure:HLTH HAZ: WATERING, HDCHS, NAUS, DIZZ & LOSS OF
COORD ARE INDICATIONS THAT SOLV LEVELS ARE TOO HIGH. INTENTIONAL
MISUSE BY DELIB CONC & INHALING CONTENTS CAN BE HARMFUL/FATAL.
CHRONIC: AVOID LONG-TERM & RPTD CNTCT. LONG-TERM EXPOS TO
CRYSTALLINE SILICA/QUARTZ MAY ALSO LEAD TO DISABLING INJURY KNOWN
AS (ING 10)
Medical Cond Aggravated by Exposure:NOT APPLICABLE.
First Aid
First Aid:INGEST: IF SWALLOWED, DO NOT INDUCE VOMITING. GENTLY WIPE OUT
INSIDE MOUTH TO REMOVE ANY RESIDUAL MATL. EYES: IN CASE OF EYE
CNTCT, REMOVE CONTACT LENSES & FLUSH EYES IMMED W/GENTLE STREAM OF
LUKEWARM WATER FOR AT LEAST 15 MIN. SKIN: IN CASE OF SKIN CNTCT,
FLUSH IMMED W/PLENTY OF WATER FOR AT LEAST 15 MIN FOLLOWED BY
WASHING W/SOAP & WATER. INHAL: IF AFFECTED BY INHAL OF VAPOR OR
SPRAY (ING 16)
Fire Fighting
Flash Point Method:PMCC
Flash Point:107F,42C
Lower Limits:1.0%
Extinguishing Media:USE NFPA CLASS B EXTINGS (CARBON DIOXIDE, DRY CHEM
OR UNIVERSAL QA FILM FORMING FOAM) DESIGNED TO EXTING NFPA (SUPDAT)
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP .
WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS BUILD-UP & POSS (SUPDAT)
Unusual Fire/Explosion Hazard:WHEN PROD IS USED, OVERSPRAY & OTHER
COMBUST MATLS SUCH AS PAINT BOOTH FILTERS, RAGS, MASKING MATLS,
ETC, CONTAM BY COATING MATL ARE SUBJECT TO SPONT (SUPDAT)
Accidental Release
Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED
W/PROPER NIOSH APPRVD RESP PROT & SKIN & EYE PROT SHOULD BE
PERMITTED IN AREA. REMOVE ALL SOURCES OF IGNIT. TAKE UP SPILLED
MATL W/SAND, VERMICULITE OR OTHER N ONCOMBUST ABSORB MATL & PLACE
IN CLEAN,(ING 19)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE ABOVE 120F (48C). STORE
LARGE QUANTITIES IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF
NFPA CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:VAPS MAY COLLECT IN LOW AREAS. IF THIS MATL IS PART
OF MULTIPLE COMPONENT SYSTEM, READ MSDS FOR OTHER COMPONENT OR
COMPONENTS BEFORE BLENDING AS RSLTG MIX MAY HAVE HAZS OF ALL OF ITS
PARTS. CNTNRS SHO ULD BE GROUNDED WHEN POURING. (ING 20)
Exposure Controls
Respiratory Protection:OVEREXP TO VAPS MAY BE PREVENTED BY ENSURING
PROPER VENT CONTROLS, VAP EXHST OR FRESH AIR ENTRY. A NIOSH APPRVD
AIR PURIFYING RESP W/APPROP CHEM CARTRIDGES OR POSITIVE-PRESS,
AIR-SUPPLIED RESP MAY ALS O REDUCE EXPOS. READ RESP MFR'S (ING 21)
Ventilation:PROVIDE GEN DILUTION OR LOCAL EXHAUST VENT IN VOLUME &
PATTERN TO KEEP CONC OF INGREDS LISTED BELOW THE LOWEST (ING 23)
Protective Gloves:NEOPRENE RUBBER OR NITRILE RUBBER.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER . WEAR
PROT CLTHG. NO SPECIFIC PERMEATION/DEGRADATION TESTING HAS (ING 24)
Work Hygienic Practices:CLEAN CONTAMINATED CLOTHING AND SHOES.
Supplemental Safety and Health
EXTING MEDIA:CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC:
AUTOIGNIT/EXPLO WHEN EXPOS TO EXTREME HEAT. IF WATER USED, FOG
NOZZS PREF. EXPLO HAZ:COMBUST. WETTING CONTAM MATLS & NOT PACKING
THEM TIGHTLY TOGETHER IN REFUSE CNTNRS WILL MINIMIZEPOTNTL FOR
THIS TO OCCUR. KEEP PROD AWAY FROM HEAT, SPKS, FLAME & OTHER (ING
6)
Chemical Properties
Boiling Pt:B.P. Text:>280F,>138C
Vapor Pres:2.1
Vapor Density:HVR/AIR
Spec Gravity:1.556
Evaporation Rate & Reference:18 (BUOAC=100)
Solubility in Water:0.1%
Appearance and Odor:VISCOUS LIQUID WITH ODOR CHARACTERISTIC OF SOLVENTS
LISTED IN INGRED SECTION.
Percent Volatiles by Volume:44.850
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE THE FOLLOWING HAZ DECOMP
PRODS WHEN EXPOSED TO EXTREME HEAT: CARBON MONOXIDE; CARBON
DIOXIDE; LOWER (ING 9)
Disposal
Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WAS TE MANAGEMENT FACILITY.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.