CJYMH - LIQUEFIED PETROLEUM GAS WITH METHYL ACETYLENE PROPADIENE
- MSDS: CJYMH
- Manufacturer: BOC GROUP INC
- Product Name: LIQUEFIED PETROLEUM GAS WITH METHYL ACETYLENE PROPADIENE
- National Stock Number: 6830-00N073086
Product Identification
Product ID:LIQUEFIED PETROLEUM GAS WITH METHYL ACETYLENE PROPADIENE
MSDS Date:06/07/1996
FSC:6830
NIIN:00N073086
Status Code:A
MSDS Number: CJYMH
Responsible Party
MURRAY HILL, NJ 07974
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 908-464-8100
Preparer: LOSS CONTROL
Cage: 80382
Contractor
Telephone: 908-464-8100
Cage: 80382
Ingredients
PETROLEUM GAS (LIQUEFIED); (LIQUEFIED PETROLEUM GAS)
CAS: 68476-85-7
RTECS: SE7545000
OSHA PEL 1800 MG/M3;1000 PPM
ACGIH TLV: 1800 MG/M3;1000 PPM
PROPYNE, MIXED WITH PROPADIENE; (METHYL ACETYLENE -
CAS: 59355-75-8
RTECS: UK4920000
OSHA PEL 1000 PPM
ACGIH TLV: 1000 PPM
Hazards
LD50 LC50 Mixture:NOT AVAILABLE.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: CONTACT WITH LIQUID MAY CAUSE
FROSTBITE, IRRITATION OR BLINDNESS. SKIN: CONTACT WITH LIQUID WILL
CAUSE FROSTBITE OR IRRITATION. INGESTION: INGESTION IS UNLIKELY.
THE EFFECTS OF INGESTION ARE UNK NOWN. HOWEVER, MINIMAL HEALTH
EFFECTS ARE ANTICIPATED. CONSULT A PHYSICIAN FOR TREATMENT OR
CONTACT THE LOCAL POISON CONTROL CENTER. INHALATION: THIS GAS
MIXTURE IS A CENTRAL NERVOUS SYSTEM DEPRESSANT AND IRRITANT.
INHALATION OF LOW CONCENTRATIONS MAY CAUSE EXCITEMENT AND
DISORIENTATION. IN HIGHER CONCENTRATIONS, THIS MIXTURE MAY ACT AS
AN ASPHYXIANT SO AS TO EXCLUDE AN ADEQUATE SUPPLY OF OXYGEN T O THE
LUNGS, (EFFECTS OF OVEREXPOSURE)
Effects of Overexposure:HEALTH HAZARDS: CAUSING UNCONSCIOUSNESS AND
POSSIBLY DEATH. EFFECTS OF OXYGEN DEFICIENCY RESULTING FROM SIMPLE
ASPHYXIANTS MAY INCLUDE RAPID BREATHING, DIMINISHED MENTAL
ALERTNESS, IMPAIRED MUSCULAR C OORDINATION, FAULTY JUDGEMENT,
DEPRESSION OF ALL SENSATIONS, EMOTIONAL INSTABILITY, AND FATIGUE.
AS ASPHYXIANT PROGRESSES, NAUSEA, VOMITING, PROSTRATION, AND LOSS
OF CONSCIOUSNESS MAY RESULT, EVENTUAL LY LEADING TO CONVULSIONS,
COMA, AND DEATH. OXYGEN DEFICIENCY DURING PREGNANCY HAS PRODUCED
DEVELOPMENTAL ABNORMALITIES IN HUMANS AND EXPERIMENTAL ANIMALS.
First Aid
First Aid:EYES: NEVER INTRODUCE OIL/OINTMENT INTO EYES W/OUT MED
ADVICE! IN CASE OF FREEZING/CRYOGENIC "BURNS" BY RAPIDLY
EVAPORATING LIQ, DO NOT WASH EYES W/HOT OR EVEN TEPID WATER! REMOVE
VICTIM FROM SOURCE O F CONTAM. OPEN EYELIDS WIDE TO ALLOW LIQ TO
EVAP. IF PAIN IS PRESENT, REFER VICTIM TO OPHTHALMOLOGIST FOR
FURTHER TREATMENT & FOLLOW UP. IF VICTIM CANNOT TOLERATE LIGHT,
PROTECT EYES W/LIGHT BANDAGE/H ANDKERCHIEF. FLUSH WITH POTABLE
WATER FOR AT LEAST 15 MINUTES. SEE MD . SKIN: REMOVE CONTAM CLTHG &
FLUSH AFFECTED AREA W/LUKEWARM WATER. DO NOT USE HOT WATER. INGEST:
KEEP VICTIM CALM & WARM. ( SUP DAT)
Fire Fighting
Flash Point Method:CC
Flash Point:=-97.6C, -144.F
Autoignition Temp:=454.4C, 850.F
Lower Limits:3.0%
Upper Limits:11.0%
Extinguishing Media:WATER FOG, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:WEAR NIOSH APPROVED SELF-CONTAINED BREATHING
APPARATUS AND FULL PROTECTIVE EQUIPMENT . DO NOT EXTINGUISH. KEEP
CYLINDER COOL WITH WATER FOG. IF FLAME IS EXTINGUISHED, REMOVE ALL
SOURCES OF IGNIT ION AND ALLOW CONTENTS TO VENT. INCREASE
VENTILATION TO PREVENT FLAMMABLE MIXTURE FORMATION.
Unusual Fire/Explosion Hazard:THIS GAS IS HEAVIER THAN AIR AND MAY
TRAVEL A CONSIDERABLE DISTANCE TO AN IGNITION SOURCE. MAY BURN WITH
AN ALMOST INVISIBLE FLAME IN BRIGHT LIGHT. HAZARDOUS COMBUSTION
PRODUCTS: ACETYLIDES. SENSITIVI TY TO MECHANICAL SHOCK: NONE.
SENSITIVITY TO STATIC DISCHARGE: NONE.
Accidental Release
Spill Release Procedures:WARNING: ANY LEAKS OF MAPP PRESENT GREAT
DANGER OF EXPLOSION/FIRE. KEEP ALL SOURCES OF IGNITION AWAY.
EVACUATE ALL PESONNEL FROM AFFECTED AREA. USE APPROP PROT EQUIP. IF
LEAK IS IN USER'S EQUIP, BE CE RTAIN TO PURGE PIPING W/INERT GAS
PRIOR TO ATTEMPTING REPAIRS. IF LEAK IS IN CONTAINER/CONTAINER
VALVE, CONTACT APPROP EMERGENCY TELEPHONE NUMBER LISTED IN FIRST
PAGE/CALL YOU CLOSEST BOC LOCATION.
Handling
Handling and Storage Precautions:ELEC CLASSIFICATION: CLASS I, GROUP
NOT SPECIFIED. EARTH-BOND & GROUND ALL LINES & EQUIP ASSOC W/FUEL
GAS SYS. ELEC EQUIP SHOULD BE NON-SPKG & EXPLO-PROOF. USE ONLY IN
WELL-VENTILATED AREAS. VALVE PRO T CAPS MUST REMAIN IN PLACE UNLESS
CONTR IS SECURED W/VALVE OUTLET PIPED TO USE POINT.
Other Precautions:DO NOT DRAG, SLIDE/ROLL CYLS. USE SUITABLE HAND TRUCK
FOR CYL MOVEMENT. USE PRESS REGULATOR WHEN CONNECTING CYL TO LOWER
PRESS (<250 PSIG) PIPING/SYS. DO NOT HEAT CYL BY ANY MEANS TO INCR
DISCHARGE RA TE OF PROD FROM CYL. USE CHECK VALVE/TRAP IN DISCHARGE
LINE TO PVNT HAZ BACK FLOW INTO CYL. (FED REG S)
Exposure Controls
Respiratory Protection:RESPIRATORY PROTECTION IS NOT NORMALLY REQUIRED.
DO NOT ENTER AREA OF HIGH MAPP CONCENTRATION UNTIL FIRST PURGING
WITH INERT GAS AND THEN VENTILATING WITH AIR. USE NIOSH APPROVED
RESPIRATOR APPROPRIAT E FOR EXPOSURE OF CONCERN .
Ventilation:PROVIDE LOC EXHST/MECH VENT IF WELDING/CUTTING IN CONFINED
AREAS. IF THIS GAS IS HANDLED ROUTINELY WHERE POTENTIAL FOR LEAKS
EXISTS, ALL ELEC EQUIP (OTHER INFO)
Protective Gloves:LEATHER GLOVES WHEN WELDING, CUTTING OR BRAZING.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYEWASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA . APRON WHEN WELDING, CUTTING OR BRAZING.
Supplemental Safety and Health
FIRST AID PROC: NOTIFY MD & INFORM OF NATURE OF MATL, STATE OF VICTIM &
ANY OBSERVED SIGNS/SYMPS. INHAL: PROMPT MED ATTN IS MANDATORY IN
ALL CASES OF OVEREXP. RESCUE PERS SHOULD BE EQUIPPED W/NIOSH AP
PRVD SCBA. CONSCIOUS PERS SHOULD BE ASSISTED TO UNCONTAM AREA &
INHALE FRESH AIR. (OTHER INFO)
Chemical Properties
HCC:G2
Boiling Pt:>-47.6C, -54.F
B.P. Text:-54F TO -10F
Melt/Freeze Pt:=-120.C, -184.F
Vapor Pres:97 PSIA @ 70F
Spec Gravity:0.571 (LIQUID)
Solubility in Water:SLIGHT
Appearance and Odor:COLORLESS GAS WITH A CHARACTERISTIC, UNPLEASANT
ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
NATURAL RUBBER, COPPER ALLOYS ABOVE 65% COPPER, SILVER, MERCURY,
HALOGENS, ACIDS, METALLIC SODIUM, POTASSIUM, POTASSIUM
PERMANGANATE.
Stability Condition to Avoid:HIGH TEMPERATURES. PRODUCT WILL START TO
DECOMPOSE AT 815F (435C).
Hazardous Decomposition Products:MAY PRODUCE ACETYLIDES WHEN IN CONTACT
WITH SILVER, MAGNESIUM, OR COPPER ALLOYS ABOVE 65% COPPER.
Disposal
Waste Disposal Methods:DO NOT ATTEMPT TO DISPOSE OF RESIDUAL OR UNUSED
QUANTITIES. RETURN IN THE SHIPPING CONTAINER PROPERLY LABELED, WITH
ANY VALVE OUTLET PLUGS OR CAPS SECURED AND VALVE PROPECTION CAP IN
PLACE TO BOC GASE S OR AUTHORIZED DISTRIBUTOR FOR PROPER DISPOSAL.
DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, AND FED ERAL
REGULATIONS .
Toxicology
Toxicological Information:IRRITANT: YES. SENSITIZATION: NO. TERATOGEN:
NO. REPRODUCTIVE HAZARD: NO. MUTAGEN: NO. SYNERGESTIC EFFECTS: NONE
REPORTED.
Other Information
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
Ecology
Ecological:NO DATA GIVEN.
Transport
Transport Information:UNITED STATES DOT/CANADA TDG: PROPER SHIPPING
NAME: PETROLEUM GASES, LIQUEFIED; HAZARD CLASS: 2.1; IDENTIFICATION
NUMBER: UN 1075; SHIPPING LABEL: FLAMMABLE GAS. NOTE: SEPTEMBER 23,
1992 REVISION UPDA TED DOT SHIPPING INFORMATION AND DISPLAYED
REGISTERED TRADEMARKS FOR THE MAPP COMPONENT.
Regulatory
SARA Title III Information:SARA TITLE III - HAZARD CLASS: ACUTE HEALTH
HAZARD; FIRE HAZARD.
Federal Regulatory Information:OTHER PREC: PROTECT CYLS FROM PHYSICAL
DMG. STORE IN COOL, DRY, WELL-VENTILATED AREA AWAY FROM HEAVILY
TRAFFICKED AREAS & EMER EXITS. DO NOT ALLOW TEMP WHERE CYLS ARE
STORED TO EXCEED 125F (52C). CYLS SHOULD BE STORED UPRIGHT &
FIRMLY SECURED TO PVNT FALLING/BEING KNOCKED OVER. FULL & EMPTY
CYLS SHOULD BE SEGREGATED. USE "FIRST IN-FIRST OUT" INVENTORY SYS
TO PVNT FULL CYLS FROM BEING STORED FOR EX CESS PERIODS OF TIME.
POST "NO SMKNG/OPEN FLAMES" SIGNS IN STOR/USE AREA. THERE SHOULD BE
NO SOURCES OF IGNIT IN STOR/USE AREA. THIS FUEL GAS SHOULD NOT BE
HANDLED/USED IN METALS WHICH FORM ACETYLIDES, SUCH AS COPPER,
SILVER, (STATE REGS)
State Regulatory Information:FEDERAL REGULATIONS: MAGNESIUM/THEIR
ALLOYS. FOR ADDITIONAL RECOMMENDATIONS CONSULT COMPRESSED GAS
ASSOCIATION PAMPHLET P-1. NEVER CARRY COMPRESSED GAS
CYLINDER/CONTAINER OF GAS IN CRYOGENIC LIQUID FO RM IN ENCLOSED
SPACE SUCH AS CAR TRUNK, VAN/STATION WAGON. LEAK CAN RESULT IN
FIRE, ASPHYXIATION/TOXIC EXPOSURE. COMPRESSED GAS CYLINDERS SHALL
NOT BE REFILLED WITHOUT EXPRESS WRITTEN PERMISSION OF OW NER.
SHIPMENT OF COMPRESSED GAS CYLINDER WHICH HAS NOT BEEN FILLED BY
OWNER/WITH HIS/HER (WRITTEN) C ONSENT IS A VIOLATION OF
TRANSPORTATION REGULATIONS.