Product ID:MIL-C-22750E #36440 EPOXY F-09P328
MSDS Date:07/20/1992
FSC:8010
NIIN:01-316-3042
Status Code:A
MSDS Number: CLFGB

SHERWIN-WILLIAMS, SEAGUARD

3560 ELM AVE.
PORTSMOUTH, VA 23704
US

Emergency Phone: (800)424-9300

Info Phone: 757-397-2223

Preparer: HENRY SIMMONS

Cage: 60163

SHERWIN-WILLIAMS, SEAGUARD

PORTSMOUTH, VA 23704 US

Telephone: 757-397-2223

Cage: 60163

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3

ACGIH TLV: 10 MG/M3

SILICON DIOXIDE

AROMATIC HYDROCARBON 150

METHYL ETHYL KETONE

CAS: 78-93-3

RTECS: EL6475000

OSHA PEL 590 MG/M3;200 PPM

ACGIH TLV: 590 MG/M3;200 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

EPOXY RESIN

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Effects of Overexposure:INHALATION; IRRITATION TO RESPIRATORY TRACT,
HEADACHE, DIZZINESS AND NAUSEA. SKIN CONTACT: PRIMARY IRRITATION.
EYE CONTACT: PRIMARY IRRITATION.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.

First Aid:INHALATION: REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT A
PHYSICIAN. SKIN CONTACT. FLUSH WITH WATER. EYE CONTACT: FLUSH
IMMEDIATELY WITH LARGE AMOUNTS OF WATER. CONSULT A PHYSICIAN.

Flash Point Method:TCC
Flash Point:=-3.7C, 25.F
Lower Limits:0.9%
Upper Limits:7.0%
Extinguishing Media:FOAM, WATER FOG, DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO COOL CLOSED CONTAINERS TO
PREVENT PRESSURE BUILD-UP AND POSSIBLE AUTOIGNITION OR EXPLOSION
WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS, AND OPEN FLAME. CLOSED CONTAINER MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES, AND ANYTHING WHICH COULD CAUSE
FIRE.

Handling and Storage Precautions:STORE IN A COOL DRY AREA WITH
VENTILATION SUITABLE FOR STORING MATERIAL SHOWN IN SECTION II.
Other Precautions:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNED AREAS ONLY.

Respiratory Protection:NIOSH/OSHA APPROVE RESPIRATOR TYPES SUITABLE FOR
MATERIALS IN SECTION II RECOMMENDED/ APPROVED CHEMICAL/MECHANICAL
FILTERS RECOMMENDED WHEN VENTILATION IS RESTRICTED. APPROVED
AIRLINE TYPE RESPIRATOR OR HOODS RECOMMENDED IN CONFINED AREAS.
Ventilation:SUFFICIENT VENTILATION, IN VOLUME AND PATTERN, SHOULD BE
PROVIDED TO KEEP AIR CONTAMINATION BELOW CURRENT APPLICABLE OSHA
PERMISSIBLE LIMIT.
Protective Gloves:RECOMMENDED FOR PROLONGED OR REPEATED CONTACT.
Eye Protection:CHEMICAL GOGGLES WITH SIDE SHIELDS OR FACE SHIELD
RECOMMENDED.
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
LIKELY. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREAS ONLY.
Supplemental Safety and Health

Boiling Pt:=79.4C, 175.F
B.P. Text:175-410F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:GRAY LIQUID AND KETONE SOLVENT ODOR
Percent Volatiles by Volume:20.7%

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:AS WITH ANY OTHER ORGANIC MATERIAL,
COMBUSTION WILL PRODUCE CARBON DIOXIDE AND PROBABLY CARBON
MONOXIDE.
Hazardous Decomposition Products:OXIDIZING MATERIAL CAN CAUSE A
VIGOROUS REACTION.

Waste Disposal Methods:SOAK LIQUIDS WITH SAWDUST OR RAGS AND REMOVED.
FLUSH WITH WATER IF POSSIBLE. AVOID SKIN CONTACT. DISPOSAL SHOULD
BE MADE IN ACCORDANCE WITH LOCAL, STATE, FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.