Product ID:N-6270A 2K WHITE EPOXY; T-IV
MSDS Date:12/17/1998
FSC:8010
NIIN:01-380-2343
Status Code:A
MSDS Number: CLHVH

NILES CHEMICAL PAINT

225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377/219-236-5856

Preparer: ERNEST CARTER

Cage: 02388

NILES CHEMICAL PAINT

307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

FORMULATED AMINE

BUTYL ALCOHOL

CAS: 71-36-3

RTECS: EO1400000

OSHA PEL 300 MG/M3;100 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

AMIDOAMINE RESIN

XYLENE

CAS: 1330-20-7

RTECS: ZE2100000

ACGIH TLV: 434 MG/M3;100 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

PROPRIETARY INGREDIENTS

LD50 LC50 Mixture:NONE
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:NONE
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES:SEVERE IRRITATION, LACRIMATION, REDNESS,
BLURRED VISION. SKIN: HARMFUL IF ABSORBED THROUGH SKIN, CAN BE
ABSORBED IN TOXIC AMOUNTS ESPECIALLY FROM PROLONGED OR REPEATED
EXPOSURES. BREATHING: NASAL AND RESPIRATORY IRRITATION, CNS
DEPREESION (DIZZINESS, DROWSINESS, WEAKNESS, FATIGUE, CONFUSION)
NAUSEA, HEADACHE, VERTIGO, POSSIBLE UNCONSCIOUSNESS, EVEN
ASPHYXIATION. SWALLOWING: GASTROINTESTINAL I RRITATION, ABDOMINAL
PAIN, NAUSEA, VOMITING, DIARRHEA.
Medical Cond Aggravated by Exposure:NONE

First Aid:INHALATION: MOVE VICTIM TO FRESH AIR AT ONCE. IF BREATHING
HAS STOPPED, PERFORM ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION
AS SOON AS POSSIBLE. SKIN CONTACT: FLUSH SKIN WITH PLENTY OF WATER.
EYE C ONTACT: FLUSH EYES WITH LARGE AMOUNT OF WATER FOR AT LEAST
15 MINUTES, OCCASIONALLY LIFTING UPPER AND LOWER LIDS. GET MEDICAL
ATTENTION IMMEDIATELY. SWALLOWING: DRINK 1 OR 2 GLASSES OF WATER.
DO NOT I NDUCE VOMITING. CONSULT A PHYSICIAN.

Flash Point Method:TCC
Flash Point:=38.3C, 101.F
Autoignition Temp:Autoignition Temp Text:NONE
Lower Limits:1.0
Upper Limits:15.0
Extinguishing Media:DRY CHEMICAL, FOAM, CO2.
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS WITH A
FULL FACEPIECE OPERATED IN POSITIVE PRESSURE MODE AND FULL
PROTECTIVE CLOTHING. WATER MAY BE USED TO COOL CLOSED CONTAINERS TO
PREVENT PRESSURE BUILD UP AND POSSIBLE AUTO IGNITION OR EXPLOSION
WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. VAPORS
ARE HEAVIER THAN AIR AND MAY TRAVEL ALONG THE GROUND TO AN IGNITION
SOURCE. ISOLATE FROM HEAT, SPARKS, ELECTRICAL EQUIPMENT, AND OPEN
FLAME. CLOSED CONTAINERS MA Y EXPLODE WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. MINIMIZE THE
BREATHING OF VAPORS AND AVOID SKIN CONTACT. ABSORB WITH AN INERT
MATERIAL SUCH AS CLAY, SOIL, OR A COMMERCIALLY AVAILABLE ABSORBENT.
SHOVEL RECLAIMED LIQUI D AND ABSORBENT INTO RECOVERY OR SALAGE
DRUMS FOR DISPOSAL.
Neutralizing Agent:NONE

Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURE
AREAS OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT
IN USE. AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMPTY DRUMS. SHOCK FROM DROPPING
MAY SPLIT CONTAINER.

Respiratory Protection:WEAR AN APPROPRIATE (TYPE TC-23C-75) PROPERLY
FITTED HALF-MASK OR FULL FACEPIECE RESPIRATOR (NIOSH/MSHA ) DURING
AND AFTER APPLICATION UNLESS AIR MONITORING DEMONSTRATES VAPOR/MIST
LEVELS ARE BELOW AP PLICABLE LIMITS. FOLLOW RESPIRATOR
MANUFACTURER'S DIRECTIONS FOR USE.
Ventilation:SUFFICIENT VENTILATION IN VOLUME AND PATTERN SHOULD BE
PROVIDED TO KEEP THE AIR CONCENTRATION BELOW CURRENT APPLICABLE
OSHA PERMISSIBLE EXPOSURE.
Protective Gloves:WEAR CHEMICAL RESISTANT (NITRILE OR VITON) GLOVES AND
CLOTHING AS NEEDED.
Eye Protection:WEAR CHEMICAL GOGGLES, SAFETY GLASSES, OR FACE SHIELDS.
Other Protective Equipment:EMPLOYEES SHOULD WASH PROMPTLY WHEN SKIN
BECOMES CONTAMINATED. REMOVE ANY CLOTHING THAT BECOMES WET.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING, OR USING
RESTROOM.
Supplemental Safety and Health
NONE

Boiling Pt:=185.C, 365.F
Melt/Freeze Pt:M.P/F.P Text:NONE
Decomp Temp:Decomp Text:NONE
Vapor Density:HEAVIER
Spec Gravity:1.413
VOC Grams/Liter:2.75
Viscosity:70-81
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS.
Percent Volatiles by Volume:40.58
Corrosion Rate:MINIMAL

Stability Indicator/Materials to Avoid:YES
OXIDIZERS, STRONG OXIDIZERS AND ACIDS, WILL SOFTEN POLYETHYLENE,
POLYPROPYLENE, PVC CONTAINERS, NONE KNOWN, STRONG OXIDIZERS.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL,
STATE, AND FEDERAL REGULATIONS.

SARA Title III Information:NONE
Federal Regulatory Information:THIS PRODUCT DOES NOT CONTAIN
INGREDIENTS LISTED IN APPENDIX A AND B AS AN EXTREMELY HAZARDOUS
SUBSTANCE. M.S.D.S. REQUIREMENTS: OUR HAZARD EVALUATION HAS FOUND
THIS PRODUCT TO BE HAZARDOUS. THE PRODU CT SHOULD BE REPORTED UNDER
THE FOLLOWING EPA HAZARD CATEGORIES.
State Regulatory Information:

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.