Product ID:RTV157
MSDS Date:03/17/2000
FSC:8040
NIIN:00-181-8380
Status Code:A
MSDS Number: CLPWY

GE SILICONES

260 HUDSON RIVER ROAD
WATERFORD, NY 12188
US

Emergency Phone: 518-237-3330

Info Phone: 518-237-3330

Preparer: ERNEST CARTER

Cage: 01139

GENERAL ELECTRIC CO, SILICONE PRODUCTS BUSINESS DEPT

WATERFORD, NY 12188 US

Telephone: 518-237-3330/800-332-3390

Cage: 01139

METHYLTRIACETOXYSILANE

CAS: 4253-34-3

RTECS: VV4500000

POLYDIMETHYLSILOXANE SILANOL/STPD

CAS: 70131-67-8

SILANOL/STPD SILOXANE W/ME SLSOXNS

CAS: 68554-67-6

D4 & HMDZ TREATED SILICON DIOXIDE

CAS: 68937-51-9

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGESTION: MAY BE HARMFUL IF
SWALLOWED. SKIN CONTACT: UNCURED PRODUCT CONTACT WILL IRRITATE
LIPS, GUMS AND TONGUE. UNCURED PRODUCT CONTACT MAY IRRITATE THE
SKIN. INHALATION: CAUSES IRRITATION OF THE M OUTH, NOSE, AND
THROAT. EYE CONTACT: UNCURED PRODUCT CONTACT IRRITATES EYES.
Explanation of Carcinogenicity:THIS PRODUCT OR ONE OF ITS INGREDIENTS
PRESENT 0.1% OR MORE IS NOT LISTED AS A CARCINOGEN OR SUSPECTED
CARCINOGEN BY NTP, IARC, OR OSHA.
Effects of Overexposure:GRAY SOLID VINEGAR ODOR AVOID CONTACT WITH SKIN
AND EYES.UNCURED PRODUCT CONTACT IRRITATES EYES. REFER TO OTHER
MSDS SECTIONS FOR DETAILED INFORMATION. ACETIC ACID RELEASED
DURING CURING. THIS PRODUC T CONTAINS METHYLPOLYSILOXANES WHICH CAN
GENERATE FORMALDEHYDE AT APPROX 300 DEG F AND ABOVE IN ATMOSPHERES
WHICH CONTAIN OXYGEN.

First Aid:INGESTION: DO NOT INDUCE VOMITING. SLOWLY DILUTE WITH 1-2
GLASSES OF WATER OR MILK AND SEEK MEDICAL ATTENTION.SKIN: TO CLEAN
FROM SKIN, REMOVE COMPLETELY WITH A DRY, CLOTH OR PAPER TOWEL,
BEFORE WASH ING WITH DETERGENT AND WATER. INHALATION: MOVE PERSON
TO FRESH AIR. EYES: IMMEDIATELY FLUSH EYES WITH PLENTY OF WATER FOR
AT LEAST 15 MINUTES AND GET MEDICAL ATTENTION.

Extinguishing Media:ALL STANDARD FIREFIGHTING MEDIA.

Spill Release Procedures:WIPE, SCRAPE OR SOAK UP IN AN INERT MATERIAL
AND PUT IN A CONTAINER FOR DISPOSAL. WASH WALKING SURFACES WITH
DETERGENT AND WATER TO REDUCE SLIPPING HAZARD. WEAR PROPER
PROTECTIVE EQUIPMENT AS SPECOFIE D IN THE PROTECTIVE EQUIPMENT
SECTION.

Handling and Storage Precautions:AVOID CONTACT WITH SKIN AND EYES.
REMOVE CONTACT LENSES BEFORE USING SEALANT. DO NOT HANDLE LENSES
UNTIL ALL SEALANT HAS BEEN CLEANED FROM THE FINGERTIPS, NAILS AND
CUTICLES. RESIDUAL SEALANT MAY REM AIN ON FINGERS FOR SEVERAL DAYS
AND TRANSFER TO LENSES AND CAUSE SEVERE EYE IRRITATION. PRODUCT
REL

Respiratory Protection:USE APPROVED NIOSH RESPIRATORY PROTECTION IF
TLV EXCEEDED OR OVEREXPOSURE IS LIKELY.
Ventilation:USE ONLY IN WELL VENTILATED AREA.
Protective Gloves:RUBBER GLOVES. CLOTH GLOVES.
Eye Protection:SAFETY GLASSES.
Supplemental Safety and Health

Spec Gravity:1.1
VOC Pounds/Gallon:42
Evaporation Rate & Reference:<1
Solubility in Water:INSOLUBLE
Appearance and Odor:SOLID ACETIC ACID GREY 1.0
Percent Volatiles by Volume:<3.8

Stability Indicator/Materials to Avoid:YES
Hazardous Decomposition Products:CARBON MONOXIDE. CARBON DIOXIDE.
SILICON DIOXIDE. ACETIC ACID. FORMALDEHYDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSAL SHOULD BE MADE IN ACCORDANCE WITH
FEDERAL, STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.