Product ID:INTERSHIELD PRORECO 508 MEDIUM BLUE, PRA551
MSDS Date:03/11/1997
FSC:NIIN:Submitter:N EN
Status Code:A
MSDS Number: CLQNG

Emergency Phone: 800-854-6813

Info Phone: 713-684-1563;908-964-2206

Cage: UO738

Telephone: 713-684-1244

Cage: 028S6

METHYL N-AMYL KETONE

CAS: 110-43-0

RTECS: MJ5075000

OSHA PEL 465 MG/M3;100 PPM

ACGIH TLV: 233 MG/M3;50 PPM

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAUSES NOSE AND THROAT
IRRITATION. EYE CONTACT: CAUSES EYE IRRITATION. SKIN CONTACT: CAUSE
SKIN IRRITATION. CAN BE ABSORBED THROUGH THE SKIN. MAY CAUSE ORGAN
DAMAGE. INGESTION: MAY BE FATA L IF SWALLOWED AND MAY CAUSE ORGAN
DAMAGE.

First Aid:GENERAL: IN ALL CASES OF DOUBT, OR WHEN SYMPTOMS PERSIST,
SEEK MEDICAL ATTENTION. NEVER GIVE ANYTHING BY MOUTH TO AN
UNCONSCIOUS PERSON. INHALATION: REMOVE TO FRESH AIR. IF DISCOMFORT
IS PRESENT OR BR EATHING IS ABSENT GET MEDICAL ATTENTION
IMMEDIATELY. EYE CONTACT: FLUSH IMMEDIATELY WITH PLENTY OF WATER
FOR 15 MINUTES UNTIL IRRITATION SUBSIDES. IF IRRITATION PERSISTS,
GET MEDICAL ATTENTION. SKIN C ONTACT: FLUSH WITH LARGE AMOUNTS OF
WATER. USE SOAP IF AVAILABLE. REMOVE SEVERELY CONTAMINATED CLOTHING
(INCLUDING SHOES) AND WASH BEFORE REUSE. IF IRRITATION PERSISTS,
GET MEDICAL ATTENTION. INGESTIO N: IF SWALLOWED, (NEUTRALIZING
AGENT)

Flash Point:=37.8C, 100.F
Lower Limits:1
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:USE A NIOSH APPROVED SELF-CONTAINED BREATHING
APPARATUS AND FULL PROTECTIVE EQUIPMENT . IN THE ABSENCE OF
ELECTRICITY, A WATER SPRAY (A FOG NOZZLE IS PREFERRED) MAY BE USED
TO COOL CONTAINERS.
Unusual Fire/Explosion Hazard:OSHA CLASSIFICATION: COMBUSTIBLE LIQUID -
CLASS II. ISOLATE FROM HEAT, SPARKS, ELECTRICAL EQUIPMENT AND OPEN
FLAME. CLOSED CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.
DECOMPOSITION AND COMBU STION PRODUCTS MAY BE TOXIC.

Spill Release Procedures:CONTAIN SPILLED LIQUID WITH SAND OR EARTH. DO
NOT USE COMBUSTIBLE MATERIALS SUCH AS SAWDUST. ABSORB SPILL WITH AN
INERT MATERIAL (E.G., DRY SAND OR EARTH), THEN PLACE IN A CHEMICAL
WASTE CONTAINER.
Neutralizing Agent:N/P. FIRST AID (CON'T): DO NOT INDUCE VOMITING.
KEEP AT REST. GET PROMPT MEDICAL ATTENTION.

Handling and Storage Precautions:KEEP CONTAINER CLOSED. LOOSEN CLOSURE
CAUTIOUSLY BEFORE OPENING. STORE IN A COOL, WELL VENTILATED PLACE
AWAY FROM INCOMPATIBLE MATERIALS (SEE REACTIVITY SECTION). KEEP
AWAY FROM HEAT, SPARKS AND FLAME S. PROTECT MATERIAL FROM DIRECT
SUNLIGHT. GROUND AND BOND CONTAINERS WHEN (OTHER PRECAUTIONS)
Other Precautions:HANDLING/STORAGE (CON'T): TRANSFERRING MATERIALS.
EMPTY CONTAINERS MAY RETAIN HAZARDOUS PROPERTIES. FOLLOW ALL
MSDS/LABEL WARNINGS, EVEN AFTER THE CONTAINER IS EMPTIED.

Respiratory Protection:USE A RESPIRATOR APPROVED BY THE NATIONAL
INSTITUTE FOR OCCUPATIONAL SAFETY AND HEALTH (NIOSH) OF THE
DEPARTMENT OF HEALTH AND HUMAN SERVICES AND IN ACCORDANCE WITH
29CFR 1910.134 TO REMOVE PARTICULAT ES (AND VAPORS IF THERE IS
OVEREXPOSURE TO VAPORS GENERATED DURING WELDING OR CUTTING ON
SURFACES COATED WITH THIS PRODUCT. )
Ventilation:PROVIDE SUFFICIENT VENTILATION, IN VOLUME AND PATTERN, TO:
A) KEEP TLV OF HAZARDOUS INGREDIENTS BELOW LIMITS SPECIFIED IN
INGREDIENTS (SUPPLEMENTAL SAFETY)
Protective Gloves:WEAR CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEMICAL SAFETY GOGGLES AND FULL
FACESHIELD .
Other Protective Equipment:EYEWASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA . AS NEEDED, USE BODY PROTECTION TO AVOID CONTACT
WITH PRODUCT.
Work Hygienic Practices:N/P.
Supplemental Safety and Health
N/P (VENTILATION CONT) SECTION. B) REMOVE VOLATILES PRODUCED DURING
CURE AND DECOMPOSITION PRODUCTS PRODUCED DURING WELDING OR CUTTING
ON SURFACES COATED WITH THIS PRODUCT.

Boiling Pt:=151.7C, 305.F
Vapor Density:> THAN AIR
Spec Gravity:1.227
Evaporation Rate & Reference:SLOWER/ETHER.
Appearance and Odor:LIQUID. ODOR NOT SPECIFIED BY MFR .

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING. FUMES MAY PRODUCE CARBON
DIOXIDE AND CARBON MONOXIDE.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

Toxicological Information:THERE IS NO DATA AVAILABLE ON THE PRODUCT
ITSELF.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Ecological:THERE IS NO DATA AVAILABLE ON THE PRODUCT ITSELF.

Transport Information:DOT (DEPARTMENT OF TRANSPORTATION): PROPER
SHIPPING NAME: PAINT. PACKING GROUP: NOT REGULATED.

SARA Title III Information:SUPERFUND AMENDMENTS AND REAUTHORIZATION
ACT: SECTION 302 REPORTABLE INGREDIENTS: NONE KNOWN. SECTION 313
REPORTABLE INGREDIENTS: 1344-28-1, ALUMINUM OXIDE (FIBROUS FORMS).
Federal Regulatory Information:TSCA (TOXIC SUBSTANCE CONTROL ACT):
COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY. CERCLA
(COMPREHENSIVE RESPONSE COMPENSATION AND LIABILITY ACT):
MANUFACTURER RECOMMENDS CONTACTING LOCA L AUTHORITIES TO DETERMINE
IF THERE MAY BE OTHER LOCAL REPORTING REQUIREMENTS. WHMIS
CLASSIFICATION: NOT REGULATED.
State Regulatory Information:CALIFORNIA PROPOSITION 65: NONE KNOWN
UNLESS SPECIFIED. WARNING: THIS PRODUCT CONTAINS A CHEMICAL KNOWN
TO THE STATE OF CALIFORNIA TO CAUSE CANCER.