CLRYD - NEOPRENE RUBBER ADHESIVE MA412
- MSDS: CLRYD
- Manufacturer: TACC INTERNATIONAL CORP
- Product Name: NEOPRENE RUBBER ADHESIVE MA412
- National Stock Number: 8040-00-165-8614
Product Identification
Product ID:NEOPRENE RUBBER ADHESIVE MA412
MSDS Date:05/17/2000
FSC:8040
NIIN:00-165-8614
Status Code:A
MSDS Number: CLRYD
Responsible Party
ROCKLAND, MA 02370
US
Emergency Phone: (800)424-9300
Info Phone: 617-878-7015
Preparer: HENRY SIMMONS
Cage: 0HZV1
Contractor
Telephone: 617-878-7015
Cage: 0HZV1
Ingredients
ACETONE
CAS: 67-64-1
RTECS: AL3150000
OSHA PEL 2400 MG/M3;1000 PPM
ACGIH TLV: 500 PPM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
NAPHTHA, SOLVENT
CAS: 8052-41-3
RTECS: WJ8925000
OSHA PEL 2900 MG/M3;500 PPM
ACGIH TLV: 525 MG/M3;100 PPM
TOLUENE
CAS: 108-88-3
RTECS: XS5250000
OSHA PEL see Table Z-2
ACGIH TLV: 188 MG/M3;50 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
HEXANE
CAS: 110-54-3
RTECS: MN9275000
OSHA PEL 1800 MG/M3;500 PPM
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
ETHANOL
CAS: 64-17-5
RTECS: KQ6300000
OSHA PEL 1900 MG/M3;1000 PPM
ACGIH TLV: 1880 MG/M3;1000 PPM
CYCLOHEXANE
CAS: 110-82-7
RTECS: GU6300000
OSHA PEL 1050 MG/M3;300 PPM
ACGIH TLV: 1030 MG/M3;300 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
Hazards
Effects of Overexposure:INGESTION: CAN CAUSE GASTROINTESTINAL
IRRITATION, NAUSEA AND VOMITING, ASPIRATION OF
MATERIALS INTO LUNGS MAY CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL.
INHALATION: MAY CAUSE NOSE OR THROAT IRRIT ATION. HIGH CONCENTRATION
MAY CAUSE
ACUTE CENTRAL NERVOUS SYSTEM DEPRESSION CHARACTERIZED BY HEADACHES,
DIZZINESS,
NAUSEA AND CONFUSION. EYES: MAY CAUSE SEVERE EYE IRRITATION AND CORNEAL
DAMAGED. SK
IN: MAY CAUSE DERMATITIS. MAY CAUSE DEFATTING AND IRRITATION OF THE
SKIN.
First Aid
First Aid:EYES: FLUSH WITH LARGE AMOUNTS OF WATER, LIFTING UPPER AND
LOWER LIDS OCCASIONALLY.
GET MEDICAL ATTENTION. SKIN: THOROUGHLY WASH EXPOSED AREA WITH SOAP AND
WATER.
REMOVE CONTAMINATED CLOTHING AND LAU NDER BEFORE REUSE. INGESTION: DO
NOT INDUCE
VOMITING, KEEP PERSON WARM, QUIET, AND GET MEDICAL ATTENTION
(ASPIRATION OF THIS
MATERIAL INTO THE LUNGS DUE TO VOMITING CAN CAUSE CHEMICAL PNEUMONITIS
WHI CH CAN
BE FATAL.) INHALATION: REMOVE INDIVIDUAL TO FRESH AIR AND IF BREATHING
IS DIFFICULT,
ADMINISTER OXYGEN.
Fire Fighting
Flash Point:=-28.7C, -20.F
-20F - -104F
Lower Limits:1.1%
Upper Limits:12.3%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER SPRAY OR
FOG.
Fire Fighting Procedures:WEAR A SELF CONTAINED BREATHING APPARATUS.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR AND MAY
TRAVEL TO AN IGNITION SOURCE DISTANT FROM THE MATERIAL HANDLING
POINT.
Accidental Release
Spill Release Procedures:KEEP SPECTATORS AWAY. ELIMINATE ALL IGNITION
SOURCES (FLAMES, HOT SURFACES AND
SOURCES OF ELECTRICAL, STATIC OR FRICTIONAL SPARKS) DIKE AND CONTAIN
SPILL WITH INERT
MATERIAL (E.G. SAND, RECOVERY OR DI SPOSAL, OR REMOVE WITH INERT
ABSORBENT. USE ONLY
NON-SPARKING TOOLS. PLACE ABSORBENT DIKING MATERIALS IN SEWERS, STREAMS
AND
GROUNDWATER WITH SPILLED MATERIAL OR USED ABSORBENT.
Handling
Handling and Storage Precautions:KEEP CONTAINER CLOSED WHEN NOT IN USE.
STORE AT 60-96 DEGREES F AND OUT OF THE SUN.
USE ADEQUATE VENTILATION TO AVOID BREATHING VAPORS WHEN COVER IS
REMOVED. GROUND
ALL EQUIPMENT WHEN HANDLING FLAMMAB LE SOLVENTBORNE MATERIALS.
Other Precautions:CONTAINERS MAY BE HAZARDOUS WHEN EMPTY. NEVER USE
WELDING OR CUTTING TORCH ON OR
NEAR DRUM (EVEN WHEN EMPTY)
Exposure Controls
Respiratory Protection:IF WORKPLACE EXPOSURE LIMIT OF PRODUCT IS
EXCEEDED, A NIOSH/MSHA APPROVES AIR SUPPLIED RESPIRATOR IS ADVISED
IN ABSENCE OF PROPER ENVIRONMENTAL CONTROL. ENGINEERING OR
ADMINISTRATIVE CONTROLS SHOULD B E IMPLEMETED TO REDUCE EXPOSURE.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW PEL.
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:CHEMICAL SPLASH GOGGLES IN COMPLIANCE WITH OSHA
REGULATIONS ARE ADVISED.
Other Protective Equipment:TO PREVENT REPEATED, PROLONG SKIN CONTACT,
WEAR IMPERVIOUS CLOTHING AND BOOTS.
Supplemental Safety and Health
Chemical Properties
Boiling Pt:=-17.6C, 0.F
B.P. Text:0-315F
Spec Gravity:0.814
Evaporation Rate & Reference:> THAN N-BUTYL ACETATW
Appearance and Odor:AMBER
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ACIDS AND BASES.
Stability Condition to Avoid:FIRE, SPARKS, STATIC ELECTRICITY.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE.
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.
Regulatory
SARA Title III Information:SARA TITTLE III SECTION 313: THIS PRODUCT
CONTAINS THE FOLLOWING CHEMICALS TO THE REPORTING REQUIREMENTS OF
SECTION 313 OF THE EMERGENCY PLANNING AND COMMUNITY RIGHT TO KNOW
ACT OF 1986 AND OF 40 CFR 372: TOLUENE
108-88-3 7-13% HEXANE 110-54-3 3-7% CYCLOHEXANE 110-82-7 1-5%
Federal Regulatory Information:THE FOLLOWING INGREDIENTS ARE
REGISTERED FOR TSCA 12B ACETONE 67-64-1 25-50% HEXANE 110-54-3
3-7% CYCLOHEXANE 110-82-7 1-5%
State Regulatory Information:PROP 65 (TERATOGEN) WARNING: THIS PRODUCT
CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARM. TOLUENE 108-88-3 7-13%
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.